UBI EasyCoder 401 ? Technical Manual CONTENTS
UBI EasyCoder 401 ? Technical Manual CONTENTS
UBI EasyCoder 401 ? Technical Manual CONTENTS
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Self-Adhesive Labels<br />
<strong>UBI</strong> <strong>EasyCoder</strong> <strong>401</strong> – <strong>Technical</strong> <strong>Manual</strong><br />
PAPER DIMENSIONS, cont'd.<br />
b<br />
a<br />
c<br />
d<br />
SELF-ADHESIVE<br />
LABELS<br />
PAPER FEED<br />
DIRECTION<br />
1 /. The last third of a label with<br />
maximum length cannot be used for<br />
printing! Also see “Max. printable<br />
length”.<br />
b<br />
e<br />
← a → Web Width<br />
(including backing paper):<br />
Maximum .................................................. : 120.0 mm (4.72")<br />
Minimum ................................................... : 25.4 mm (1.00")<br />
The backing paper must not extend more than a total of 1.6 mm (0.06")<br />
outside the paper (← b →) and should protrude equally on both sides.<br />
← c → Label Width<br />
(excluding backing paper):<br />
Maximum .................................................. : 118.4 mm (4.66")<br />
Minimum ................................................... : 23.8 mm (0.94")<br />
← d → Label Length:<br />
Max. label length 1 ...................................... : 1875 mm (73.8")<br />
Min. label length ........................................ : 10 mm (0.39")<br />
Max. printable length ................................. : 1250 mm (49.2")<br />
← e → Label Gap:<br />
Maximum .................................................. : 10.0 mm (0.39")<br />
Recommended ........................................... : 1.6 mm (0.06")<br />
Minimum ................................................... : 1.2 mm (0.05")<br />
The adjustable label stop sensor must be able to detect the extreme front and<br />
rear edges of the labels. Therefore, do not use larger inner corner radii than<br />
can be compensated for by adjusting the sensor's position, i.e. ≈ 50 mm<br />
(1.97").<br />
38