POWER-MASTER 500 - Victor Technologies

More documents

Recommendations

Info

Rear Panel Figure 2–4 Rear Panel 13 14 15 16 17 Art # A-04101 13. 14 Pin Receptacle: This receptacle allows the power source to interface with wire feeders, and remote controls such as a foot pedal. This receptacle provides auxiliary power, contactor control for energizing the output of the power source, and remote output control. The pinout is as follows: A) 24 VAC auxiliary power high side B) 24 VAC Contactor circuit, (closure between pin A and pin B will energize output). C) Remote control maximum (top side of remote pot.) D) Control circuit common E) Remote control in (wiper of remote pot., 0 to 10 Volts). CV mode: 0 to 10 Volts gives 10 – 44 Volts of output. CC mode: 0 to 10 Volts gives 5 – 560 Amps of output. F) Scaled output current signal Ifb = 100 Amps/Volt G) 24/115 VAC neutral H) Output voltage signal: 10 Volts/Volt I) 115 VAC auxiliary power high side J) 115 VAC Contactor circuit, (closure between pin I and pin J will energize output). K) Chassis ground L) N/C M) N/C N) N/C 14. 19 Pin Receptacle: This receptacle allows the power source to interface with wire feeders, and remote controls such as a foot pedal. This receptacle provides auxiliary power, contactor control for energizing the output of the power source, and remote output control. The pinout is as follows: A) Contactor circuit (+15 Volts) B) Contactor circuit in, (closure between pin A and pin B will energize output). C) Scaled output voltage signal: Vfb = 10 Arc Volts/ Volt D) 24 VAC auxiliary power high side E) 115 VAC auxiliary power high side F) 24/115 VAC neutral G) Chassis ground H) Remote control maximum (top side of remote pot.) J) Remote control in (wiper of remote pot., 0 to 10 Volts).CV Mode: 0 to 10 Volts gives 0 – 44 Volts of output. CC Mode: 0 to 10 Volts gives 0 – 560 Amps of output. K) Remote control minimum (bottom side of remote pot.) L) Control circuit common M) Arc Established = +12 Volts N) Control circuit common P) 24 VAC auxiliary power high side (same as pin D) R) 24/115 VAC neutral (same as pin E) S) N/C T) N/C INTRODUCTION 2-8 MANUAL 430429-485
U) Scaled output current signal: Ifb = 100 Amps/Volt V) N/C If a remote control is plugged into both the 14 pin and 19 pin receptacles the device plugged into the 19 pin receptacle will have control over the output current or voltage. Either device can control the output contactor circuit. 15. Duplex: This receptacle can provide up to 10 amps of 120 VAC auxiliary power for powering wire feeders, water circulators, etc. 16. Fuse: This fuse protects the control transformer in the power source. If the fuse opens it should be replaced with a like amperage and voltage, (20 amps, 600VAC). 17. Input Power Access: This opening provides access to the input terminal block for the input cable. See installation chapter of this manual for detailed instructions. MANUAL 430429-485 2-9 INTRODUCTION
Page 1: POWER-MASTER 500 450 Amp Inverter W
Page 4 and 5: TABLE OF CONTENTS SECTION 1: ARC WE
Page 7 and 8: SECTION 1: ARC WELDING SAFETY INSTR
Page 9 and 10: 5. Work in a confined space only if
Page 11 and 12: WARNING STEAM AND PRESSURIZED HOT C
Page 13 and 14: 8. N’utilisez pas de câbles éle
Page 15 and 16: AVERTISSEMENT LES ETINCELLES ET LES
Page 17 and 18: DECLARATION OF CONFORMITY Manufactu
Page 19 and 20: SECTION 2: INTRODUCTION 2.01 How To
Page 21 and 22: 2.05 General The Power-Master 500 i
Page 23 and 24: 2.07 Standard Features The power so
Page 25: 6. Meter Display: The digital meter
Page 29 and 30: 3.01 Location SECTION 3: INSTALLATI
Page 31 and 32: 3.05 Grounding The frame of this we
Page 33 and 34: 3.07 Configuration Settings A. Lift
Page 35 and 36: 4.01 General SECTION 4: OPERATION R
Page 37 and 38: SECTION 5: SERVICE 5.01 General Mai
Page 39 and 40: 3. Machine powers up but fans do no
Page 41 and 42: SECTION 6: PARTS LIST 6.01 Equipmen
Page 43 and 44: 6.04 Base Parts Item Qty. Descripti
Page 45 and 46: 6.06 Rear Panel Parts Item Qty. Des
Page 47 and 48: 26 25 19 9 1 18 27 7 6 11 30 24 23
Page 49 and 50: APPENDIX 1: GENERAL INFORMATION Not
Page 51 and 52: Art # A-04106 MANUAL 430429-485 A-3
Page 53 and 54: Art # A-04107 MANUAL 430429-485 A-5
Page 55: Art # A-04108 MANUAL 430429-485 A-7

POWER-MASTER 500 - Victor Technologies

Create successful ePaper yourself

Delete template?

Save as template?