Installation of Fixed Capacitive HSWIM Sensors

Material: (nominally for one sensor installation)
Item Description
Minimum
Quantity
1 Capacitive WIM sensor As required
2 Installation frame As required
3 Support brackets for installation 1 set
3 Installation frame kit complete (shims, bolts, anchors, earth wire) As required
4 20 liter epoxy kit (10 L part A and 10 L part B) per sensor As required
5 50 kg clean dry silica filler sand As required
6 5 litre acetone cleaner As required
7 Sealing putty (500 gm) As required
8 Silicone sealant (one tube) As required
9 Loctite 243 medium strength 1 medium
10 Flexible seal (ABE hot-melt) or equivalent 10 kg As required
11 20 spare 10 mm x 20 bolts for blocking mounting holes As required
12 Release agent (500gm beeswax clear polish) 1
Equipment:
Item Description
Minimum
Quantity
1 Pavement breaker with 20mm and 40mm bit (adequate strength) 1
2 25mm diameter 300mm long concrete drill bit 1
3 Straight-edge (3m) 1
4 Torque wrench (100 N*m) 1
5 Steel rule and or graded wedge 1
6 Disposable gloves 50
7 Bucket measure (15 liter) 4
8 Mixing bucket (25 liter minimum) (clean and uncontaminated) 2
9 Tarpaulin (10m x 5m) 1
8 Spiral mixing paddle 1
9 Hilti (Kango) hammer action drill (adequate size) 1
10 10mm Tap set (with cleaning tap) 1
Test equipment:
All equipment as listed in loop installation document
Item Description
Minimum
Quantity
1 Mikros Systems Weighing Logger 1
2 Laptop with Telcom 1
3 Infrared thermometer 1
MS001-96100-52 Installation of Fixed Capacitive HSWIM Sensors Issue5 1 March 2005
30 / 56