Steel Protection Submittal - Hilti Egypt

More documents

Recommendations

Info

Fire Protection Steel Spray CFP-S WB EMERGENCY AND FIRST AID PROCEDURES Eyes: Skin: Inhalation: Ingestion: Other: MSDS No.: 332 Revision No.: 003 Revision Date: 10/13/10 Page: 2 of 2 Flush with plenty of water for at least 15 minutes. Contact a Physician if symptoms occur. Wash with soap and water. Remove contaminated clothing. Contact a Physician if symptoms occur Move victim to fresh air. Contact a Physician if symptoms occur. Do not induce vomiting unless directed by a Physician. Contact a Physician immediately. Referral to a Physician is recommended if there is any question about the seriousness of the injury/ exposure. CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENT Ventilation: Eye Protection: Skin Protection: Respiratory Protection: General (natural or mechanically induced fresh air movements). While spraying, chemical goggles are recommended. Impermeable gloves recommended. Use other protective clothing as required to prevent skin contact. None normally required. Where ventilation is inadequate to control vapors, use a NIOSH approved respirator with organic vapor cartridge. If dusts are generated during demolition or removal, wear an appropriate dust mask or respirator. PRECAUTIONS FOR SAFE HANDLING AND USE Handling and Storing Precautions: Spill Procedures: REGULATORY INFORMATION Hazard Communication: HMIS Codes: DOT Shipping Name: IATA / ICAO Shipping Name: TSCA Inventory Status: SARA Title III, Section 313: EPA Waste Code(s): Waste Disposal Methods: CONTACTS Store in a cool dry area. Keep from freezing. Store between 40° and 77° F. For industrial use only. Keep out of reach of children. Use with adequate ventilation. Keep container closed when not in use. Do not get into the eyes. Avoid prolonged or repeated contact with the skin. Practice good hygiene; i.e. wash after using and before eating or smoking. Wipe away spilled material before it hardens. Place in a container for proper disposal in accordance with all applicable local, state, or federal requirements. This MSDS has been prepared in accordance with the federal OSHA Hazard Communication Standard. 29 CFR 1910.1200. Health 1, Flammability 0, Reactivity 0, PPE B (Glasses, Gloves) Not regulated. Not regulated. Chemical components listed on TSCA inventory. This product does not contain any toxic chemicals which are subject to reporting under Section 313 of SARA Title III (40 CFR Part 372). Not regulated by EPA as a hazardous waste Consult with regulatory agencies or your corporate personnel for disposal methods that comply with local, state, and federal safety, health and environmental regulations. Customer Service: 1 800 879 8000 Technical Service: 1 800 879 8000 Health / Safety: Emergency # (Chem-Trec): 1 800 879 6000 Jerry Metcalf (x1003704) 1 800 424 9300 (USA, PR, Virgin Islands, Canada); 001 703 527 3887 (other countries) The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or warranty of any kind expressed or implied is made with respect to the information provided. 10 Hilti, Inc. (USA) 1-800-879-8000 I www.us.hilti.com I en español 1-800-879-5000 I Hilti (Canada) Corp. 1-800-363-4458 I www.hilti.ca I CFP-S WB Submittal Information 8/2011
August 6, 2010 To Whom It May Concern: Re: Hilti CFP-S WB Steel Spray — LEED Info. The Hilti CFP-S WB Steel Spray is manufactured in Germany. The CFP-S WB Steel Spray pail is made of polyethylene and can be completely recycled. There is no post-consumer or post-industrial content in CFP-S WB Steel Spray and it cannot be recycled. The CFP-S WB Steel Spray does not contain any Rapidly Renewable Materials. The VOC content in CFP-S WB Steel Spray is 49 g/l. CFP-S WB Steel Spray is not regulated as a hazardous waste by the Federal EPA Standards. The regulations for the disposal of non-regulated industrial waste can vary from state to state and even city to city. For this reason, you should consult your local and state regulatory agencies for direction on disposal. Please feel free to contact me at (918) 872-3704 if you have questions. Sincerely, Jerry Metcalf MPH, CHMM Safety/Environmental Manager Hilti Inc w (918) 872 3704 jerry.metcalf@hilti.com Rev. Date: 8/6/10-1 Hilti, Inc. (US) 5400 South 122nd East Avenue Tulsa, OK 74146 1-800-879-8000 www.us.hilti.com
Page 1 and 2: Fire Protection Steel Spray CFP-S W
Page 9: Fire Protection Steel Spray CFP-S W

Steel Protection Submittal - Hilti Egypt

Create successful ePaper yourself

Delete template?

Save as template?