Ref: Stock 105' Aerial Specifications - R & R Fire Truck Repair, Inc.

Demo #3708 Smeal Fire Apparatus Co. 105’ Heavy Duty Aerial
12 VOLT SYSTEMS TEST
After completion of the unit, the 12 volt electrical system shall undergo a battery of tests as listed in
the latest addition of NFPA Pamphlet 1901. These tests shall include, but not be limited to: a
reserve capacity test, alternator performance test at idle, alternator performance test at full load,
and a low voltage alarm test. Certification of the results shall be supplied with the apparatus at the
time of delivery.
REAR WORK LIGHT SWITCH
A switch shall be installed above the tail light bezel on the left side. The switch shall be wired to the
backup lights to provide additional work lighting. The rear work light circuit shall be deactivated
when the park brake is disengaged. In addition to the lights being activated by the above switch,
the lights shall also come on when the transmission is placed in reverse.
MIDSHIP TURN SIGNAL ( LED )
There shall be one (1) Truck-Lite model 21 LED midship auxiliary / turn signal lights installed in the
rub rail, on each side of the body.
LED CLEARANCE LIGHTS
Truck-Lite model 30 LED red clearance lights shall be installed on the rear of the body as
necessary to be in full compliance with applicable ICC and DOT codes and regulations.
GROUND LIGHTING
Truck-Lite model 40 lights shall be installed beneath the apparatus in areas where personnel may
be expected to climb on and off of the apparatus. The lights shall illuminate the ground within 30"
of the apparatus to provide visibility of any obstructions or hazards. These areas shall include, but
not be limited to, side running boards and the rear step area.
WALKWAY LIGHTS
Lights shall be mounted in a manner that illuminates all walkways and steps for safe operation of
the apparatus. These lights shall become illuminated when the parking brake is engaged.
ROM COMPARTMENT LIGHTING
All compartments that are equipped with a ROM rollup door and have an opening of less than 42"
shall be furnished with one (1) ROM LED compartment light mounted on the front corner of the
compartment.
All compartments that are equipped with a ROM rollup door and have a door opening that is 42"
wide or wider shall have a light installed on the front and rear corner of the compartment.
An automatic door switch shall activate these compartment lights.
PUMP COMPARTMENT LIGHTS, TRUCK LITE
There shall be two (2) Truck-Lite model 40 incandescent lights installed in the pump compartment.
The lights shall be activated by an automatic switch in the right side pump compartment access
door and shall be located in a manner that will provide maximum lighting.
Revised 3/19/09 Page 40 of 112