2011 3 Series Owner's Manual without iDrive - Irvine BMW
2011 3 Series Owner's Manual without iDrive - Irvine BMW
2011 3 Series Owner's Manual without iDrive - Irvine BMW
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Driving<br />
Warning lamps<br />
The indicator 2 flashes in red; a<br />
signal sounds.<br />
The system indicates that you<br />
must brake and/or maneuver the<br />
vehicle yourself. Active cruise control<br />
cannot automatically restore the distance to<br />
the vehicle ahead.<br />
This indicator does not release you from your<br />
responsibility to adapt your desired speed and<br />
driving style to prevailing driving conditions.<br />
The indicator 2 flashes in yellow.<br />
The prerequisites for operating<br />
active cruise control are not met,<br />
e.g. as a result of ABS or DSC<br />
interventions. Active cruise control<br />
is deactivated. You can reactivate the system, if<br />
desired, by tapping or pulling the lever when<br />
road and traffic conditions permit. It is not possible<br />
to resume a stored speed.<br />
For US owners only<br />
The transmitter and receiver units comply with<br />
part 15 of the FCC/Federal Communications<br />
Commission regulations. Operation is governed<br />
by the following:<br />
FCC ID:<br />
NF3 ACC2SCU 003YK04001 0000<br />
Compliance statement:<br />
This device complies with part 15 of the FCC<br />
Rules. Operation is subject to the following two<br />
conditions:<br />
> This device must not cause harmful interference,<br />
and<br />
> this device must accept any interference<br />
received, including interference that may<br />
cause undesired operation.<br />
Any unauthorized modifications or<br />
changes to these devices could void the<br />
user’s authority to operate this equipment.<<br />
Radar sensor<br />
Malfunction<br />
The warning lamp comes on when<br />
the system has failed. More information<br />
can be found beginning on<br />
page 164.<br />
The sensor's ability to detect vehicles ahead<br />
may be restricted as a result of heavy rain, dirt,<br />
snow or ice. If necessary, clean the radar sensor<br />
located in the front bumper, see arrow. Be sure<br />
to use particular care when removing any layers<br />
of snow or ice from the sensor.<br />
The system cannot be activated if the sensor is<br />
incorrectly aligned.<br />
68