download - DIA Business Center Home Page - Denver International ...

TECHNICAL SPECIFICATIONS
DENVER INTERNATIONAL AIRPORT
DIVISION 1 – GENERAL REQUIREMENTS
RUNWAY 17R-35L COMPLEX PAVEMENT REHABILITATION
SECTION 01050 01 32 23 – LAYOUT OF WORK AND SURVEYS CONTRACT NO.: 201208806
of other utility components such as telephone or light poles, manholes, boxes, etc., visible on the
airport.
5.07 PROPERTY BOUNDARY SURVEYING/LAND-USE
A. All property surveys on airport property need to comply with the requirements for the State of
Colorado and be conducted by a licensed surveyor in the state. For more details please see the
following links.
Colorado State Constitution
Article XX – Home Rule
http://www.michie.com/colorado/
Colorado Revised Statutes Regarding Land Surveying
http://www.dora.state.co.us/aes/Statute-PLS.pdf
State Board Rules and Regulations
http://www.dora.state.co.us/aes/AES2008_Rules_Bylaws_II.pdf
State Board Policies
http://www.dora.state.co.us/aes/Policies-PEPLS.pdf
City and County of Denver Municipal Code
Chapter 49 – Article III Layout of Streets
Chapter 50 Subdivision of Land
http://www.municode.com/Resources/gateway.asp?pid=10257&sid=6
B. When necessary, the surveyor will set boundary monuments in accordance with the accepted
surveying practice and legal requirements so that, upon completion of the survey, each corner of the
property and each referenced control stations will be physically monumented. When it is impossible
or impracticable to set a boundary monument on a corner, the surveyor will set a reference
monument, similar in character to the boundary monument and preferably along one of the property
lines intersecting at the corner. When a reference monument is used, clearly identify it as a reference
monument on the plat of the property and in any new deed description, written for the property. Every
boundary monument and/or reference monument set by the surveyor will, when practicable:
1. Be composed of a durable material.
2. Have a minimum length of thirty inches with a 2 inch minimum diameter durable metallic
cap
3. Have a minimum cross-section area of material of 0.2 square inches.
4. Be identified with a durable marker bearing the surveyor's registration
5. Number of (PLS) with company name and date, should be stamped on the cap
6. Be detectable with conventional instruments for finding ferrous or magnetic objects.
C. When a case arises due to physical obstructions where a boundary or reference monument cannot
ISSUED FOR BID: 11/26/2012 RS&H Revision No. 2012
01050 01 32 23 - 13