EXCLUSIVE LIFETIME REPAIR OR REPLACE ... - Auroralight

LSR5-L VERTEX
The vertex is a low-energy recessed mount LED step
light that offers excellent low-level illumination. Its
progressive engineering and state-of-the-art machining
allow for the faceplate and light engine to be adjusted
to level even if the included stainless steel back box is
installed up to 1/2” out of plumb. The included highdensity
EPDM rubber gasket ensures that the internal
components are protected from moisture and prevents
unwanted stray light. The heavy machined grill and
finned design provide the ideal heat-sink for up to 5
watts of cutting-edge high-brightness LEDs, comparable
to a 20 watt halogen source. The LED control module
is sealed into the luminaire with thermally conductive
epoxy and allows the fixture to operate on standard
12 volt systems with no additional hardware needed.
Intended for exterior concrete pour, brick and block
installations. Available with brass, copper or stainless
steel trim.
ORdERING GUIdE: LSR5-L
L (LED) S (STEPLIGhT) r5 (rECTAnGLE 5”) L (LOUvEr)
Light Source:
LED Life (L70):
Input Voltage:
Current Rating:
Watts:
Color Temperature:
CRI:
**
12 VOLT
Remote
Transformer
Required
FACEPLATE WATTAGE FINISHES EXAMPLE
[BR] BrASS
[CU] COPPEr
[SS] STAInLESS
[2.5W] 2.5WATTS
[5W] 5 WATTS
** Consult the factory for custom finish.
high-brightness LED
Lens:
50,000 hours average*
Faceplate:
5 to 15v AC or DC
Back Box:
700ma (0.70 Amps)
Conduit Entries:
2.5W or 5W
Gasket:
2900 CCT (k) Typical Operating Temperature:
80 Typical
Certification:
*LED life is defined as the time to 70% lumen maintenance (L70)
3 1/8”
79mm
2 3/16”
55mm
1”
50mm
[NAT] nATUrAL
[BLP] BrOnZE LIvInG PATInA
SPECIFICATIONS
52
4 13/16”
122mm
4”
102mm
1/2” Or 3/4” COnDUIT EnTrY (8)
3”
76mm
2 1/2”
63mm
LSR5-L-BR-2.5w-NAT
Brass Faceplate
Frosted Pyrex Glass
Brass, Copper, Stainless Steel with Brass or Stainless Steel hardware
Stainless steel (supplied)
1/2 – 3/4” (8)
EPDM
-31 to 124˚F (-35 – 51˚C)
Wet location and concrete pour
UL standard 1838
LSR5-L VERTEX