FS-C8026N Service Manual - kyocera

2BF
1-3-2 Installing expansion memory (optional)
1. Turn off printer power.
* Caution: Do not insert or remove expansion
memory while printer power is on.
Doing so may cause damage to the printer
and the expansion memory.
2. Remove two screws and then remove the
main controller PWB.
Screws
Main controller PWB
Figure 1-3-14
3. Open the stoppers of the memory socket.
4. Insert the memory so that the two notches of
the memory are engaged with the projections
of the memory socket.
5. Close the stoppers of the memory socket.
6. Reattach the main controller PWB in the
printer.
7. Print a status page to check the memory
expansion.
* If memory expansion has been properly performed,
information on the installed memory
is printed with the total memory capacity has
been increased. Standard memory capacity
128 MB.)
Stopper
Memory socket
Memory (DIMM)
Stopper
Figure 1-3-15
1-3-10