Nice Robus Kit 1 - Rolling Center

2.2) Typical system
Figure 2 shows a typical system for automating a sliding gate using ROBUS
1
4 3 5
3 8
9
12
6
7
2
11
13
10
F
B
A
D
2
E C F
C
2
1 Key-operated selector switch
2 Photocells on post
3 Photocells
4 Main fixed edge (optional)
5 Main movable edge
6 “Open” stop bracket
7 Rack
8 Secondary fixed edge (optional)
9 Flashing light with incorporated aerial
10 ROBUS
11 “Closed” stop bracket
12 Secondary movable edge (optional)
13 Radio-transmitter
2.3) List of cables
Figure 2 shows the cables needed for the connection of the devices in a typical installation; table 5 shows the cable characteristics.
! The cables used must be suitable for the type of installation; for example, an H03VV-F type cable is recommended for indoor
applications, while H07RN-F is suitable for outdoor applications.
Table 5: List of cables
Connection Cable type Maximum length allowed
A: Power line 1 3x1,5mm 2 cable 30m (note 1)
B: Flashing light with aerial 1 2x0,5mm 2 cable 20m
1 RG58 type shielded cable 20m (recommended less than 5 m)
C: Photocells 1 2x0,5mm 2 cable 30m (note 2)
D: Key-operated selector switch 2 2x0,5mm 2 cable (note 3) 50m
E: Fixed edges 1 2x0,5mm 2 cable (note 4) 30m
F: Movable edges 1 2x0,5mm 2 cable (note 4) 30m (note 5)
Note 1:
Note 2:
Note 3:
Note 4:
Note 5:
power supply cable longer than 30 m may be used provided it has a larger gauge, e.g. 3x2,5mm 2 , and that a safety grounding system
is provided near the automation unit.
If the “BLUEBUS” cable is longer than 30 m, up to 50 m, a 2x1mm 2 cable is needed.
A single 2x0,5mm 2 cable can be used instead of two 4x0,5mm 2 cables.
Please refer to Chapter “7.3.2 STOP Input” in situations where there is more than one edge, for information about the type of connection
recommended by the manufacturer.
special devices which enable connection even when the leaf is moving must be used to connect movable edges to sliding leaves.
6