SecureStream IP Receiver - Security Help Desk

Figure 5: SecureStream IP start screen
Setting up SecureStream IP software
This procedure assumes that the following are successfully installed and configured:
• Challenger panel(s) with TS0898 Ethernet Interfaces installed.
• One or more SecureStream IP Receivers.
• The central monitoring station software.
• Suitable management software.
Trained Installation Technicians may use the following overall process to set up SecureStream IP
software.
Step
Instructions
1 Configure the Challenger panels for event-driven mode (i.e. UDP/IP mode). See the TS0898
Ethernet Interface Installation and Programming Guide for details.
2 If ARES or Forcefield management software is present, set up the IP configuration for
SecureStream IP Receiver and the panels for your network.
3 Change the network address in Linux (using the Network configuration editor) for the
SecureStream IP Receiver.
4 Use the SecureStream IP configuration editor to set up various global options related to
various SecureStream IP Challenger panels.
5 Set up SecureStream IP operators’ qualifications (i.e., access rights).
6 Add SecureStream IP operators, give them passwords, and assign qualifications to them.
7 Check that the panels in the system are online and the monitoring station is receiving CID
events.
8 Set up any Challenger panels using management software.
9 Resolve any problems with offline panels, such as incorrect host names.
12 SecureStream IP Receiver Installation & Programming Guide 2.0