Novell eDirectory 8.8 Troubleshooting Guide - NetIQ

Trace Flag Parameters Description
!EO None Schedules the outbound synchronization process to begin
execution.
*F None Schedules the flat cleaner process, which is part of the
janitor process, to begin execution on the source server in
five seconds.
novdocx (en) 11 July 2008
!F Time Sets the interval (in minutes) for the flat cleaner process.
Default=240 minutes (4 hours)
Range=2 to 10080 minutes (168 hours)
*G Replica rootEntry ID Rebuilds the change cache of the specified root partition ID.
*H None Schedules the replica synchronization process to begin
execution immediately on the source server.
!H Time Sets the interval (in minutes) for the heartbeat
synchronization process.
Default=30 minutes
Range=2 to 1440 minutes (24 hours)
*HR None Clears the in-memory last-sent vector.
*I Replica rootEntry ID Adds the specified local entry ID to the source server’s Send
All Object list. The entry ID must specify a partition root
object that is specific to the server’s local database. The
replica synchronization process checks the Send All Object
list. If the entry ID of a partition’s root object is in the list,
eDirectory synchronizes all objects and attributes in the
partition, regardless of the value of the Synchronized Up To
attribute.
!I Time Sets the interval (in minutes) for the heartbeat
synchronization process.
Default=30 minutes
Range=2 to 1440 minutes (24 hours)
*J None Schedules the purge process, which is part of the replica
synchronization process, to begin running on the source
server.
!J Time Sets the interval (in minutes) for the janitor process.
Default=2 minutes
Range=1 to 10080 minutes (168 hours)
*L None Schedules the limber process to begin running on the
source server in five seconds.
*M Bytes Changes the maximum file size used by the source server’s
ndstrace.log file. The command can be used regardless of
the state of the debug file. The bytes specified must be a
hexadecimal value between 10000 bytes and 100 MB. If the
value specified is higher or lower than the specified range,
no change occurs.
!M None Reports the maximum memory used by eDirectory.
76 Novell eDirectory 8.8 Troubleshooting Guide