Novell eDirectory 8.8 Troubleshooting Guide - NetIQ

Trace Flag Parameters Description
!N 0|1 Sets the name form.
0=hex only
1=full dot form
*P None Displays the tunable parameters and their default settings.
novdocx (en) 11 July 2008
*R None Resets the TTF file, which is the sys:system\ndstrace.dbg
file by default. This command is the same as the SET
parameter NDS Trace File Length Set to Zero.
*S None Schedules the Skulker process, which checks whether any
of the replicas on the server need to be synchronized.
!SI Time Sets the interval (in minutes) for the inbound schema
synchronization process.
Default=24 minutes
Range=2 to 10080 minutes (168 hours)
!SO Time Sets the interval (in minutes) for the outbound schema
synchronization process.
Default=24 minutes
Range=2 to 10080 minutes (168 hours)
!SIO Time Disables the inbound schema synchronization process for
the specified number of minutes.
Default=24 minutes
Range=2 to 10080 minutes (168 hours)
!SO0 Time Disables the inbound schema synchronization process for
the specified number of minutes.
Default=24 minutes
Range=2 to 10080 minutes (168 hours)
*SS None Forces immediate schema synchronization.
*SSA None Schedules the schema synchronization process to begin
immediately and forces schema synchronization with all
target servers, even if they have been synchronized in the
last 24 hours.
*SSD None Resets the source server’s Target Schema Sync list. This list
identifies which servers the source server should
synchronize with during the schema synchronization
process. A server that does not hold any replicas sends a
request to be included in the target list of a server that
contains a replica with its Server object.
*SSL None Prints the schema synchronization list of target servers.
*ST None Displays the status information for the background
processes on the source server.
*STX None Displays the status information for the backlink process
(external references) on the source server.
Troubleshooting Utilities on Linux and UNIX 77