PowerLinx Multi-channel Sound Reinforcement Systems - Tannoy
PowerLinx Multi-channel Sound Reinforcement Systems - Tannoy
PowerLinx Multi-channel Sound Reinforcement Systems - Tannoy
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
POWERLINX PRODUCTS<br />
{<br />
5<br />
PLA305 5-Channel Power Amplifier<br />
The PLA305 amplifier resides in the 110 series subwoofer cabinet. All internal woofer connections are made for<br />
you at the factory. Four external 50 watt full-range speaker connector sets are accessible on the front panel of the PLA305.<br />
1<br />
2<br />
3<br />
1) PREAMP INPUT<br />
Accepts the supplied 30 cable from the PLC4.1. Audio signals from and power to the PLC4.1 are routed via this<br />
cable. Note that the PLC4.1 module may be temporarily located remotely, with the 12 cable option,<br />
to facilitate system set-up<br />
2) SPEAKER OUTPUTS<br />
Four separate 50 watt speaker-level outputs are provided. Each output should be limited to a minimum of 3 ohms<br />
speaker load. Wire connections are made via spring-loaded push-and-release connectors (maximum wire size; 14<br />
gauge). Your choice of plenum-rated speaker wire should be made with consideration for length of run and damping<br />
characteristics. Be sure to observe consistent phasing of your full-range speakers and avoid shorting of<br />
speaker wires.<br />
3) POWER CORD<br />
110VAC 60 Hz 5A. A standard 2-prong plug is provided. There is no power switch on the PLA305. Automatic power<br />
on/off is made in the presence or absence of an audio signal.