User Manual K1297-G20 Monitor Protocol Tester ... - TRS-RenTelco
User Manual K1297-G20 Monitor Protocol Tester ... - TRS-RenTelco
User Manual K1297-G20 Monitor Protocol Tester ... - TRS-RenTelco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Appendix A: Interfaces<br />
In addition an RJ45 10-BaseT/100-BaseT connector is provided on the<br />
AP-4 or AP-4/256 front panel (for future use, not yet supported).<br />
1<br />
Table A–15: Pin assignment for the 10Base-T/100Base-Tx interface<br />
Pin Assignment Pin Assignment<br />
1 TD + 5 Not connected<br />
2 TD – 6 RD –<br />
3 RD + 7 Not connected<br />
4 Not connected 8 Not connected<br />
The two switches on the front panel have the following function:<br />
ABT<br />
Abort (for future use, not yet software supported)<br />
RST<br />
Reset all onboard devices<br />
CAUTION. ABT and RST are for future use. They are not yet supported.<br />
Please do not touch.<br />
The four status LEDs on the front panel have the following meaning:<br />
BFL<br />
Board failure<br />
CPU<br />
CPU is accessing the bus<br />
PMC<br />
Top PCI mezzanine card, if installed, is active<br />
PMC<br />
Bottom PCI mezzanine card, if installed, is active<br />
A-26 <strong>K1297</strong>-<strong>G20</strong> <strong>Monitor</strong> <strong>User</strong> <strong>Manual</strong>