User Manual K1297-G20 Monitor Protocol Tester ... - TRS-RenTelco

More documents

Recommendations

Info

Examples 3. Select the protocol from the protocol list on the basis of which the calltrace is to be performed. 4. Confirm your selection with Load. The CallTr/Seq_1: ISUP ITU-T White book window then appears (example). Depending on the Calltrace selected this window can slightly vary. 82 K1297-G20 Monitor User Manual
Examples 5. Enter the phone number you are looking for under Search for. You can enter up to four numbers divided by commas (,). The following wildcards for digits are allowed: + for exactly one digit or no digit, * for any number of digits, ? for exactly one digit. You can enter more than one asterisk (*) within a calling number (for example *123*678). One asterisk is always automatically entered at the end of the number. Thus, numbers that are too long can be found. If calling numbers are initiated by + or * the filter mode starts working only after the number is confirmed by an ACM (Address complete) or an ANM (Answer message). That means that all messages are transmitted until then, because they belong to a call with a corresponding number. If you are looking for numbers with prefixes (for example international area code) at one and the same time, you will get more specific outputs by entering the exact numbers (for example 4930386,30386) than by entering numbers initiated by “+” or “*” (++30386,*30386). 6. Specify whether the phone number designates a Calling Party or a Called Party in the Type of number field. 7. Specify whether it is a National, an International or a Subscriber number without a national/international area code in the Nature of Address field. Select don’t care to include all numbers. 8. For protocols you can specify Cause Values as additional search criteria. The Calltrace application then searches for calls that contain the desired number and one of the selected cause values (reason for the end of call). 9. Specify the number of calls to be traced in the Trace mode field: one (Single) or any number of matching phone numbers (Multiple). If you activate the filter mode, only the calltrace messages will be displayed. Other messages will be suppressed. The asterisk (*) at the beginning leads to more detailed infomation. K1297-G20 Monitor User Manual 83
Page 1 and 2:
User Manual K1297-G20 Monitor Proto
Page 3:
WARRANTY Tektronix warrants that th
Page 6 and 7:
Contents Appendix D: Windows XPe Tr
Page 8 and 9:
General Safety Summary Use Proper A
Page 10 and 11:
General Safety Summary Terms on the
Page 12 and 13:
Service Safety Summary viii K1297-G
Page 14 and 15:
Preface K1297 and K1297 Compact. Th
Page 16 and 17:
Preface Prerequisites You should ha
Page 18 and 19:
Preface About the User Manual The U
Page 20 and 21:
Preface Contacting Tektronix Addres
Page 22 and 23:
Getting Started Device Description
Page 24 and 25:
Getting Started 3. Take the cable o
Page 26 and 27:
Getting Started 3. Fold the device
Page 28 and 29:
Getting Started 4. Push the front c
Page 30 and 31:
Getting Started Connecting an Exter
Page 32 and 33:
Getting Started Operating only the
Page 34 and 35:
Getting Started Before writing a
Page 36 and 37:
Getting Started K1297 Compact. For
Page 38 and 39:
Getting Started Exchanging Measurin
Page 40 and 41:
Getting Started The following color
Page 42 and 43:
Getting Started Setting the VME Bus
Page 44 and 45: Getting Started K1297. Make sure th
Page 46 and 47: Getting Started Removing Modules If
Page 48 and 49: Getting Started Switching on the De
Page 50 and 51: Getting Started K1297-G20 Monitor A
Page 52 and 53: Getting Started Measurement Scenari
Page 54 and 55: Getting Started Software Installati
Page 56 and 57: Getting Started Pre-Installation Ch
Page 58 and 59: Getting Started Installation of Add
Page 60 and 61: Getting Started 5. In the product s
Page 62 and 63: Getting Started Back Up the Softwar
Page 64 and 65: Getting Started 5. In the product s
Page 66 and 67: Getting Started Operating System Th
Page 68 and 69: Getting Started Autologon Account.
Page 70 and 71: Getting Started Ethernet Connection
Page 72 and 73: Getting Started Remote Operation Re
Page 74 and 75: Getting Started Connecting Peripher
Page 76 and 77: Examples Online Monitoring in a Net
Page 78 and 79: Examples NOTE. The data line has no
Page 80 and 81: Examples The right side of the wind
Page 82 and 83: Examples The data in each view is c
Page 84 and 85: Examples Recording and Reviewing Mo
Page 86 and 87: Examples Press Browse, if you want
Page 88 and 89: Examples Reviewing Recorded Data Pr
Page 90 and 91: Examples 4. If you want to filter t
Page 92 and 93: Examples Preliminary Steps The Prot
Page 96 and 97: Examples 10. Click Start to start C
Page 98 and 99: Examples Examples. The number you w
Page 100 and 101: Examples 88 K1297-G20 Monitor User
Page 102 and 103: Appendix A: Interfaces System Unit
Page 104 and 105: Appendix A: Interfaces Reset. To re
Page 106 and 107: Appendix A: Interfaces Additional K
Page 108 and 109: Appendix A: Interfaces Parallel Int
Page 110 and 111: Appendix A: Interfaces Ethernet BNC
Page 112 and 113: Appendix A: Interfaces External Mon
Page 114 and 115: Appendix A: Interfaces USB (Univers
Page 116 and 117: Appendix A: Interfaces The synchron
Page 118 and 119: Appendix A: Interfaces Table A-12:
Page 120 and 121: Appendix A: Interfaces PC Card Slot
Page 122 and 123: Appendix A: Interfaces Figure A-1:
Page 124 and 125: Appendix A: Interfaces Working With
Page 126 and 127: Appendix A: Interfaces In addition
Page 128 and 129: Appendix A: Interfaces 8 1 S 0 4 1
Page 130 and 131: Appendix A: Interfaces Line status.
Page 132 and 133: Appendix A: Interfaces U 2B1Q Inter
Page 134 and 135: Appendix A: Interfaces Pin Assignme
Page 136 and 137: Appendix A: Interfaces B Channel Ac
Page 138 and 139: Appendix A: Interfaces V./X. Board
Page 140 and 141: Appendix A: Interfaces Each termina
Page 142 and 143: Appendix A: Interfaces Table A-25:
Page 144 and 145:
Appendix A: Interfaces Table A-26:
Page 146 and 147:
Appendix A: Interfaces Table A-27:
Page 148 and 149:
Appendix A: Interfaces The followin
Page 150 and 151:
Appendix A: Interfaces 9-pin D-Sub
Page 152 and 153:
Appendix A: Interfaces 8 1 Ethernet
Page 154 and 155:
Appendix A: Interfaces The two swit
Page 156 and 157:
Appendix A: Interfaces Defining CPU
Page 158 and 159:
Appendix A: Interfaces A-58 K1297-G
Page 160 and 161:
Appendix B: Keyboard Alphanumeric K
Page 162 and 163:
Appendix B: Keyboard Table B-1: Spe
Page 164 and 165:
Appendix B: Keyboard Language Suppo
Page 166 and 167:
Appendix B: Keyboard Switching the
Page 168 and 169:
Appendix B: Keyboard Deactivating a
Page 170 and 171:
Appendix B: Keyboard B-12 K1297-G20
Page 172 and 173:
Appendix C: Specifications Table C-
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Appendix C: Specifications CAUTION.
Page 180 and 181:
Appendix D: Windows XPe Troubleshoo
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Abbreviations HLR Home location reg
Page 194 and 195:
Abbreviations SMS Short message ser
Page 196 and 197:
Index E E1/DS1 Monitoring Board, A-
Page 198:
Index R Record Viewer, 76 Recording
show all

User Manual K1297-G20 Monitor Protocol Tester ... - TRS-RenTelco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?