Participant Technical Reference Manual - IESO

4. Operational Metering Equipment & AGC IMO_MAN_0024
246 DNP (Distributed Network Protocol) is an open, standards-based protocol used
in the electric utility industry to address interoperability between substation
computers, RTUs, IEDs (Intelligent Electronic Devices) and master stations.
This protocol is based on the standards of the International Electrotechnical
Commission (IEC). DNP 3.0 is the recommended practice by the IEEE C.2
Task Force for RTU to IED communications.
247 The document "DNP 3.0 Subset Definitions" is available to DNP User Group
members at the DNP User Group Web site (http:/www.dnp.org). This
document will help DNP implementers to identify protocol elements that
should be implemented.
248 The following RTU manufacturers using the DNP 3.0 protocol have been
qualified for use by the IESO:
249 Vendor Name: GE Energy / GE Harris
250 Device Name: D20, D200, and D25 RTUs,
251 Vendor Name: Quindar
252 Device Name: XPPQ and Scout RTUs,
253 Vendor Name: PML
254 Device Name: 7330, 7500, 7600, 7700 and 8500
255 Vendor Name: Cybectec
256 Device Name: SMP Gateway
257 Vendor Name: Schneider Electric
258 Device Name: Quantum PLC System with a DNP3 Processor,
259 Vendor Name: Bow Networks
260 Device Name: Advantech Industrial PC Part # UNO-2160-IDA0
261 Vendor Name: Schweitzer Engineering Laboratories, Inc.
262 Device Name: SEL-3332 Intelligent Server.
263 Vendor Name: Telvent
264 Device Name: Sage 3030 Substation Automation Platform.
265 Vendor Name: Schweitzer Engineering Laboratories, Inc.
266 Device Name: SEL-3351, 3354 & 3530 System Computing Platform.
267 Vendor Name: ABB
268 Device Name: ABB RTU560
269 Vendor Name: Subnet Solutions Inc.
270 Device Name: SEL/SUBNET 1102
271 Further information on additional qualified devices or assistance on RTU set-up
and configuration is available from the IESO.
70 Public Issue 21.1 – March 15, 2010 - estimated