Here - LF-Technik

6 ______________________________________
CAUTION: If the speed is too low the stall comes very abruptly. If you want to avoid
this, please switch OFF the control on the elevator axis.
At thermalling in circle the control for elevator and aileron should be OFF, because otherwise
the plane will not show you any more where the thermals are because it will no more “shake”
the wings for example. Control ON on the rudder axis can be wise for continuous circles with
the same diameter.
If you use a Variometer also the aileron control can be ON.
During straight flight between 2 thermal fields control ON on all axes could be useful, if there
is enough speed.
The same counts for F3B or F3F competitions.
For all gliders counts: Elevator control OFF for the landing. (Stall!).
5. For beginners:
For the beginner it is a big easing to fly with GyroBot 900 Wing.
A Trainer model with active control has no „live of its own“ anymore. Thereby the pilot must
control only if he wants to change the direction. So flying a model airplane could become
nearly as easy as driving a RC Car.
Of course there are many more Types of RC planes which flying characteristics can be
improved with the GyroBot.
Installation in the model:
Some important informations about vibrations:
You always should fix the GyroBot 900 Wing with ONE ORIGINAL SELF-ADHESIVE
PAD in the model. The GyroBot 900 Wing Jet can be mounted with one and a half Pad
(in longitudinal direction one after another).
In particular if you use large Gas Engines from 20 cc up to more than 250 cc which
cause heavy vibrations it is VERY IMPORTANT that the GyroBot is fixed on a VERY
SOLID BOARD which is connected VERY FIRMLY with the fuselage. The board MUST
NOT swing or bend itself.
The 1-2 mm thick boards in the AFR planes are UNSUITABLE.
The board should be made from min. 6-8mm thick high quality plywood.
In electric or turbine models it is less critical.
The main unit of the GyroBot 900 Wing MUST be fixed PARALLEL to all 3 main axes of
the plane.
That means, it must be parallel to the roll-axis, to the pitch-axis and to the vertical (yaw) –
axis. It should be fixed near the receiver and the power management system.
The plug board of the GyroBot must look towards the front or the rear of the plane, but
NOT to the left or to the right.
It must not be fixed in the CG of the plane.
Please ONLY USE ONE of the ORIGINAL double sided mounting pads which are included.
Please fix it on a clean, smooth and stable surface which is solidly bonded to the fuselage.
For GyroBot 900 Wing Jet you can use 1,5 Pads next to each other in the length direction.
Please consider a good adhesion of the pad and the GyroBot.