Here - LF-Technik

More documents

Recommendations

Info

8 ______________________________________ Installation in a turbine powered model Never fix the unit bevelled to one of the 3 main axes. The pitot tube must be fixed on the tip of one of the wings and parallel to the roll-axis. It must NOT be fixed on the fuselage. You can fix it with a part of one pad between the wing and the tube and with 2 or 3 stripes of adhesive film. You also can glue it into the nose of the wing, but please think of the 20 mm distance as shown in the following picture.
9 ______________________________________ Now you must halve the 3mm Festo Tube and put the 2 tubes on the 2 brass pipes of the pitot tube. (If its too loose please use VERY LESS speed glue to safe them). Before you thread the tubes through the wing you must mark both ends of one tube with a permanent marker pen. Now please thread the tubes through the wing and pull them out on the root rib. In the fuselage the 2 tubes will be connected with the extension board as shown in the pictures. Please necessarily consider the right polarity. The tube which is on the straight brass pipe of the pitot tube must be connected to the upper pin on the extension board, the tube on the angulate brass pipe must be connected to the lower pin on the extension board. Connection Schema: The right place for the Extensionboard: Ideally the Extensionboard should be fixed with a part of one included pad in the fuselage near the GyroBot main unit. The position and direction of the board is equal. If you fix it in the fuselage, you must cut both 3mm Festo tubes and connect then again with the 2 Festo connectors. Then you only have to disconnect the Festo connectors if you want to remove the wing from the fuselage.
Page 1 and 2: 1 _________________________________
Page 3 and 4: 3 _________________________________
Page 5 and 6: 5 _________________________________
Page 7: 7 _________________________________
Page 11 and 12: 11 ________________________________
Page 13 and 14: 13 ________________________________
Page 15 and 16: 15 ________________________________
Page 17 and 18: 17 ________________________________
Page 19 and 20: 19 ________________________________
Page 21 and 22: 21 ________________________________
Page 23 and 24: 23 ________________________________
Page 25 and 26: 25 ________________________________
Page 27: 27 ________________________________

Here - LF-Technik

Create successful ePaper yourself

Delete template?

Save as template?