High frequency spindles for automatic tool change GMN - Industrial ...
High frequency spindles for automatic tool change GMN - Industrial ...
High frequency spindles for automatic tool change GMN - Industrial ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94<br />
<strong>High</strong> <strong>frequency</strong> spindle <strong>for</strong> <strong>automatic</strong> <strong>tool</strong> <strong>change</strong><br />
HCS 120 - 45000/15<br />
119,9 -0,2<br />
63<br />
Power<br />
P [kW]<br />
Torque<br />
M [Nm]<br />
40<br />
8,5 0,1<br />
20<br />
16<br />
12<br />
8<br />
4<br />
5,5<br />
3<br />
M S6-40%<br />
M S6-60%<br />
M S1<br />
( 67,5 )<br />
73 Locating length 184<br />
23,5<br />
0<br />
0 9000 18000 27000 36000 45000<br />
8<br />
7<br />
6<br />
5<br />
4<br />
3<br />
2<br />
1<br />
Speed n [rpm]<br />
0<br />
0 9000 18000 27000 36000 45000<br />
Speed n [rpm]<br />
360<br />
120 h5<br />
P S1<br />
480<br />
P S6-40%<br />
P S6-60%<br />
79,5<br />
( 120 )<br />
Synchronous motor<br />
Power P (S1).......................................... 15 kW at 24,000 rpm<br />
Torque M (S1) ....................................... 6 Nm<br />
Speed n max ........................................... 45,000 rpm<br />
Drive ........................................................ closed-loop<br />
Hybrid ball bearings<br />
Bore diameter<br />
of front bearings ................................. 45 mm<br />
Lubrication ........................................... Oil/air<br />
Tool interface<br />
Interface................................................. HSK-E 40<br />
Monitoring<br />
"clamped", "unclamped",<br />
"clamped without <strong>tool</strong>".................... Proximity switches<br />
Taper cleaning ..................................... Air<br />
Static <strong>tool</strong> pull-in <strong>for</strong>ce ..................... 6.8 kN<br />
Seal ............................................................. Air purge<br />
Coolant<br />
through shaft ....................................... 80 bar<br />
Shaft movement<br />
Compensating - Axial....................... Temperature sensor<br />
Rigidity<br />
Radial...................................................... 125 N/µm<br />
Axial......................................................... 91 N/µm<br />
<strong>Industrial</strong> Technologies<br />
Also available with permanent grease lubrication.<br />
This lubrication leads to speed reduction.<br />
19
Change language