High frequency spindles for automatic tool change GMN - Industrial ...
High frequency spindles for automatic tool change GMN - Industrial ...
High frequency spindles for automatic tool change GMN - Industrial ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94<br />
<strong>High</strong> <strong>frequency</strong> spindle <strong>for</strong> <strong>automatic</strong> <strong>tool</strong> <strong>change</strong><br />
HCS 230 - 12000/30<br />
(51)<br />
Power<br />
P [kW]<br />
Torque<br />
M [Nm]<br />
40<br />
30<br />
20<br />
10<br />
130 195222<br />
107,5<br />
4,5<br />
8<br />
M S1<br />
32<br />
69<br />
79<br />
30<br />
130<br />
299<br />
232 h5<br />
0<br />
0 3000 6000 9000 12000<br />
250<br />
200<br />
150<br />
100<br />
50<br />
M S6-40%<br />
M S6-60%<br />
Speed n [rpm]<br />
Locating length<br />
P S6-40%<br />
P S6-60%<br />
P S1<br />
0<br />
0 3000 6000 9000 12000<br />
230<br />
410<br />
758,6<br />
540,7<br />
628,6<br />
Locating length<br />
231 h5<br />
30<br />
230<br />
Synchronous motor<br />
Power P (S1) ............................................. 30 kW at 1,600 rpm<br />
Torque M (S1) .......................................... 179.3 Nm<br />
Speed n max ............................................... 12,000 rpm<br />
Drive ........................................................... closed-loop<br />
Hybrid ball bearings<br />
Bore diameter<br />
of front bearings .................................... 110 mm<br />
Lubrication ............................................... Oil/air<br />
Tool interface<br />
Interface .................................................... HSK-A 100<br />
Monitoring<br />
"clamped", "unclamped",<br />
"clamped without <strong>tool</strong>" ....................... Analog sensor<br />
Taper cleaning ........................................ Air<br />
Static <strong>tool</strong> pull-in <strong>for</strong>ce ........................ 45 kN<br />
Seal ................................................................ Air purge<br />
Coolant<br />
through shaft .......................................... 50 bar<br />
through spindle housing .................... 3 bar<br />
Rigidity<br />
Radial ......................................................... 800 N/µm<br />
Axial ............................................................ 320 N/µm<br />
<strong>Industrial</strong> Technologies<br />
Speed n [rpm]<br />
Also available with permanent grease lubrication.<br />
This lubrication leads to speed reduction.<br />
30
Change language