High frequency spindles for automatic tool change GMN - Industrial ...
High frequency spindles for automatic tool change GMN - Industrial ...
High frequency spindles for automatic tool change GMN - Industrial ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94<br />
8<br />
<strong>High</strong> <strong>frequency</strong> spindle <strong>for</strong> <strong>automatic</strong> <strong>tool</strong> <strong>change</strong><br />
HCS 230g - 10000/24<br />
170185<br />
h6<br />
110<br />
88,5<br />
Power<br />
P [kW]<br />
Torque<br />
M [Nm]<br />
10,5<br />
32<br />
28<br />
24<br />
20<br />
16<br />
12<br />
8<br />
4<br />
45<br />
56,5<br />
76,5<br />
96,5<br />
230 h5<br />
30 30 46,6<br />
126,5<br />
229<br />
226,5<br />
230 h5<br />
256,5<br />
229<br />
P S6-40%<br />
P S6-60%<br />
0<br />
0 2500 5000 7500 10000<br />
120<br />
100<br />
80<br />
60<br />
40<br />
20<br />
M S6-40%<br />
M S6-60%<br />
M S1<br />
Locating length Locating length Locating length<br />
Speed n [rpm]<br />
P S1<br />
426,5<br />
230 h5<br />
473,1<br />
229<br />
623,1<br />
229,5<br />
665,1<br />
229<br />
872<br />
886,5<br />
Asynchronous motor<br />
Power P (S1) ............................................. 24 kW at 2,500 rpm<br />
Torque M (S1) .......................................... 91.7 Nm<br />
Speed n max ............................................... 10,000 rpm<br />
Drive ........................................................... closed-loop<br />
Hybrid ball bearings<br />
Bore diameter<br />
of front bearings .................................... 90 mm<br />
Lubrication ............................................... Grease<br />
Tool interface<br />
Interface .................................................... HSK-A 63<br />
Monitoring<br />
"clamped", "unclamped",<br />
"clamped without <strong>tool</strong>" ....................... Analog sensor<br />
Taper cleaning ........................................ Air<br />
Static <strong>tool</strong> pull-in <strong>for</strong>ce ........................ 18 kN<br />
Seal ................................................................ Air purge<br />
Coolant<br />
through shaft .......................................... 50 bar<br />
Rigidity<br />
Radial ......................................................... 600 N/µm<br />
Axial ............................................................ 430 N/µm<br />
960<br />
<strong>Industrial</strong> Technologies<br />
0<br />
0 2500 5000 7500 10000<br />
Speed n [rpm]<br />
Also available <strong>for</strong> oil/air lubrication.<br />
This lubrication possibly leads to increase of speed.<br />
35