High frequency spindles for automatic tool change GMN - Industrial ...
High frequency spindles for automatic tool change GMN - Industrial ...
High frequency spindles for automatic tool change GMN - Industrial ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94<br />
<strong>High</strong> <strong>frequency</strong> spindle <strong>for</strong> <strong>automatic</strong> <strong>tool</strong> <strong>change</strong><br />
HCS 230 - 30000/120<br />
10,5<br />
98<br />
84 -0,1 145<br />
196<br />
Power<br />
P [kW]<br />
Torque<br />
M [Nm]<br />
0,1<br />
558,1<br />
480<br />
115<br />
317<br />
20<br />
Locating length 20<br />
280<br />
230 h5<br />
229<br />
5<br />
40<br />
71 (44)<br />
(365)<br />
160<br />
P S6-40%<br />
P S6-60%<br />
120<br />
80<br />
40<br />
0<br />
0 6000 12000 18000 24000 30000<br />
Speed n [rpm]<br />
120<br />
M S6-40%<br />
90 M S6-60%<br />
M S1<br />
60<br />
30<br />
0<br />
0 6000 12000 18000 24000 30000<br />
Speed n [rpm]<br />
P S1<br />
48<br />
228<br />
ca. 88,6<br />
66<br />
82<br />
88,5<br />
Hub 2<br />
83<br />
ca. 73,5<br />
63,6<br />
48<br />
Synchronous motor<br />
Power P (S1) ........................................ 120 kW at 13,800 rpm<br />
Torque M (S1) ..................................... 83 Nm<br />
Speed n max .......................................... 30,000 rpm<br />
Drive ...................................................... closed-loop<br />
Hybrid ball bearings<br />
Bore diameter<br />
of front bearings............................... 70 mm<br />
Lubrication .......................................... Oil/air<br />
Tool interface<br />
Interface ............................................... HSK-A 63 / -F 80<br />
Monitoring<br />
"clamped", "unclamped",<br />
"clamped without <strong>tool</strong>" .................. Analog sensor<br />
Taper cleaning.................................... Air<br />
Static <strong>tool</strong> pull-in <strong>for</strong>ce.................... 20 kN<br />
Seal ........................................................... Air purge<br />
Coolant<br />
through shaft ..................................... 50 bar<br />
through spindle housing ............... 5 bar<br />
Shaft movement<br />
Compensating - Axial ...................... Temperature sensor<br />
Rigidity<br />
Radial..................................................... 380 N/µm<br />
Axial ....................................................... 145 N/µm<br />
Option<br />
Vibration sensor<br />
Shaft movement sensor<br />
128<br />
<strong>Industrial</strong> Technologies<br />
Also available with permanent grease lubrication.<br />
This lubrication leads to speed reduction.<br />
33
Change language