High frequency spindles for automatic tool change GMN - Industrial ...
High frequency spindles for automatic tool change GMN - Industrial ...
High frequency spindles for automatic tool change GMN - Industrial ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Индастриал Технолоджис www.ind-techno.com.ua +38 044 498 21 94<br />
<strong>High</strong> <strong>frequency</strong> spindle <strong>for</strong> <strong>automatic</strong> <strong>tool</strong> <strong>change</strong><br />
HCS 230 - 40000/22<br />
Power<br />
P [kW]<br />
Torque<br />
M [Nm]<br />
73<br />
53<br />
2 4,5<br />
64<br />
84<br />
114<br />
30<br />
Locating length 12<br />
E. M. 10,5<br />
7<br />
178<br />
180 h5<br />
225<br />
265<br />
230 h5<br />
228<br />
30<br />
25<br />
P S6-40%<br />
P S6-60%<br />
20<br />
P S1<br />
15<br />
10<br />
5<br />
0<br />
0 10000 20000 30000 40000<br />
Speed n [rpm]<br />
30<br />
25<br />
M S6-40%<br />
M S6-60%<br />
20<br />
M S1<br />
15<br />
10<br />
5<br />
Locating length 42<br />
229 g5<br />
414<br />
225<br />
483<br />
497,5<br />
128<br />
83<br />
520<br />
571,1<br />
Asynchronous motor<br />
Power P (S1).......................................... 22 kW at 10,000 rpm<br />
Torque M (S1) ....................................... 21 Nm<br />
Speed n max ........................................... 40,000 rpm<br />
Drive ........................................................ closed-loop<br />
Hybrid ball bearings<br />
Bore diameter<br />
of front bearings ................................. 55 mm<br />
Lubrication ........................................... Oil/air<br />
Tool interface<br />
Interface................................................. HSK-E 50<br />
Monitoring<br />
"clamped", "unclamped",<br />
"clamped without <strong>tool</strong>".................... Analog sensor<br />
Taper cleaning ..................................... Air<br />
Static <strong>tool</strong> pull-in <strong>for</strong>ce ..................... 10 kN<br />
Seal ............................................................. Air purge<br />
Shaft movement<br />
Compensating - Axial....................... Temperature sensor<br />
Rigidity<br />
Radial...................................................... 260 N/µm<br />
Axial......................................................... 130 N/µm<br />
<strong>Industrial</strong> Technologies<br />
0<br />
0 10000 20000 30000 40000<br />
Speed n [rpm]<br />
Also available with permanent grease lubrication.<br />
This lubrication leads to speed reduction.<br />
34