15" PLANER INSTRUCTION MANUAL - Grizzly Industrial Inc.
15" PLANER INSTRUCTION MANUAL - Grizzly Industrial Inc.
15" PLANER INSTRUCTION MANUAL - Grizzly Industrial Inc.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Dust Port<br />
Handwheel<br />
Components and Hardware Needed: ....Qty<br />
Dust Port ........................................................1<br />
Phillips Head Screw M6-1 x 12......................6<br />
Tools Needed:<br />
Phillips Head Screwdriver ..............................1<br />
It is important to install a dust collection system to<br />
the dust port.<br />
To install the dust port:<br />
1. Do not connect the planer to a power<br />
source!<br />
2. Place the dust port above the outfeed table.<br />
See Figure 9.<br />
3. Secure the dust port with the Phillips head<br />
screws provided.<br />
Components and Hardware Needed: ....Qty<br />
Handwheel ....................................................1<br />
Handwheel Handle ........................................1<br />
Hex Nut M10-1.5............................................1<br />
Flat Washer 10mm ........................................1<br />
High/Low Label ..............................................1<br />
Tools Needed:<br />
12/14mm Combo Wrench ..............................1<br />
The handwheel is used to raise and lower the<br />
planer cutterhead.<br />
To install the handwheel:<br />
1. Do not connect the planer to a power<br />
source!<br />
2. Place the handwheel over the keyed shaft<br />
shown in Figure 10. Make sure the keyway<br />
in the handwheel lines up with the key in the<br />
shaft.<br />
3. Secure the handwheel with the hex nut and<br />
washer.<br />
4. Attach the handle to the outer edge of the<br />
handwheel.<br />
5. Install the High/Low label around the hex nut.<br />
Figure 9. Dust port installed.<br />
Key<br />
Figure 10. Installing handwheel.<br />
-16- G0550/G0551 15" Planer