“A Stitch in Time...”

Megger 5 kV & 10 kV Insulation Testers
Where critical, high-capital equipment is involved, the introduction
of new and improved insulating materials is re-writing the book on
insulation testing. Equipment with operating voltages above 1 kV requires
commensurately higher test voltages. Modern materials, when new or
early in their life cycles, can have insulation values into ranges that were
previously unmeasured. Your old insulation tester may not be fully adequate
to meet the demands of a rigorous and thorough program of preventive/
predictive maintenance on modern equipment.
To be fully in conformance with the most modern testing requirements,
Megger offers a family of the highest quality insulation testers at voltages
above 1 kV. At the core of high-voltage testing...5 kV...the MIT510 and
MIT520 afford the highest level of quality testing along with prime safety,
convenience and portability. MIT510 offers selectable test voltages at
250, 500, 1000, 2500, and 5000 V, thereby making the tester suitable for
applications otherwise performed with a standard handheld model, in
addition to the more demanding high-voltage applications. The MIT520
increases the functionality by permitting test voltage to be set in any
10 V increment from 50 V to 1 kV, then in 25 V steps all the way to 5 kV.
The testers measure to 15 Tera-ohms, thereby making them fully suitable
for critical installation tests and establishment of reliable base data for new
high-capital equipment. Test results are displayed on Megger’s patented
electronic digital/analog arc, thereby affording the precision and assurance
of a digital reading combined with the tell-tale pointer travel normally
reserved for mechanical movements.
62
A STITCH IN TIME