Inst book MB-4(En).pdf - Janome
Inst book MB-4(En).pdf - Janome
Inst book MB-4(En).pdf - Janome
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Cleaning the Auto Thread Cutter Mechanism<br />
z<br />
q<br />
e<br />
r<br />
CAUTION:<br />
w<br />
Turn the power switch off before cleaning the auto<br />
thread cutter mechanism.<br />
x<br />
t<br />
z Loosen the 2 setscrews on the needle plate with<br />
the offset screwdriver.<br />
Unscrew and remove the 2 setscrews with the<br />
screwdriver<br />
q Setscrews<br />
w Needle plate<br />
e Offset screwdriver<br />
r Screwdriver<br />
x Remove the needle plate.<br />
Clean the auto thread cutter mechanism with the<br />
lint brush.<br />
t Auto thread cutter mechanism<br />
c<br />
c Replace the needle plate and attach it with the 2<br />
setscrews. Tighten the setscrew slightly.<br />
v<br />
y<br />
v Lower the needle bar by pushing it down with the<br />
small screwdriver.<br />
y Small screwdriver<br />
b Turn the handwheel in the direction of “A” to<br />
lower the needle into the hole in the needle plate.<br />
b<br />
A<br />
n<br />
B<br />
n Adjust the position of the needle plate so that<br />
needle enters into the center of the hole.<br />
u Hole in the needle plate<br />
u<br />
m<br />
m Tighten the 2 setscrew securely with the offset<br />
screwdriver.<br />
,<br />
, Turn the handwheel in the direction of “B” to<br />
raise the needle bar.<br />
78