HARMON ROCKET III - Green Hobby & Model
HARMON ROCKET III - Green Hobby & Model
HARMON ROCKET III - Green Hobby & Model
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>HARMON</strong> <strong>ROCKET</strong> <strong>III</strong>. Instruction Manual.<br />
INTRODUCTION.<br />
Thank you for choosing the Harmon Rocket <strong>III</strong> ARTF by SEAGULL MODELS. The Harmon Rocket<br />
<strong>III</strong> was designed with the intermediate/advanced sport flyer in mind. It is a semi scale airplane which<br />
is easy to fly and quick to assemble. The airframe is conventionally built using balsa, plywood to<br />
make it stronger than the average ARTF , yet the design allows the aeroplane to be kept light. You<br />
will find that most of the work has been done for you already.Flying the Harmon Rocket <strong>III</strong> is simply<br />
a joy.<br />
This instruction manual is designed to help you build a great flying aeroplane. Please read this<br />
manual thoroughly before starting assembly of your Harmon Rocket <strong>III</strong>. Use the parts listing below<br />
to identify all parts.<br />
WARNING.<br />
Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is<br />
capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU<br />
ASSUME ALL RISK & RESPONSIBILITY.<br />
If you are inexperienced with basic R/C flight we strongly recommend you contact your R/C supplier<br />
and join your local R/C <strong>Model</strong> Flying Club. R/C <strong>Model</strong> Flying Clubs offer a variety of training<br />
procedures designed to help the new pilot on his way to successful R/C flight. They will also be able<br />
to advise on any insurance and safety regulations that may apply.<br />
ADDITIONAL ITEMS REQUIRED.<br />
! .40-.46 2-stroke engine<br />
.52-.82 4-stroke engine<br />
! Computer radio with six servos<br />
! Glow plug to suit engine<br />
! Propeller to suit engine<br />
! Protective foam rubber for radio<br />
system<br />
! Silicone fuel line<br />
TOOLS & SUPPLIES NEEDED.<br />
! Thick cyanoacrylate glue<br />
! 30 minute epoxy<br />
! 5 minute epoxy<br />
! Hand or electric drill<br />
! Assorted drill bits<br />
! <strong>Model</strong>ling knife<br />
! Straight edge ruler<br />
! 2mm ball driver<br />
! Phillips head screwdriver<br />
! 220 grit sandpaper<br />
! 90° square or builder’s triangle<br />
! Wire cutters<br />
! Masking tape & T-pins<br />
! Thread-lock<br />
! Paper towels<br />
PARTS LISTING.<br />
FUSELAGE ASSEMBLY<br />
! (1) Fuselage<br />
! (1) Canopy hatch<br />
WING ASSEMBLY<br />
! (1) Right wing half with pre-installed<br />
aileron<br />
! (1) Left wing half with pre-installed<br />
aileron<br />
! (1) Aluminium dihedral brace<br />
Tail section assembly<br />
! (1) Horizontal stabilizer with preinstalled<br />
elevator halves<br />
Some more parts.<br />
HARDWARE PACK<br />
COWLING<br />
Landing gear.....<br />
2