Prestige 964 Cable Router Operator's Guide - bei GGA Maur
Prestige 964 Cable Router Operator's Guide - bei GGA Maur
Prestige 964 Cable Router Operator's Guide - bei GGA Maur
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Prestige</strong> <strong>964</strong> <strong>Cable</strong> <strong>Router</strong><br />
2.1 Front Panel LEDs and Back Panel Ports<br />
Chapter 2<br />
Hardware Installation and Initial Setup<br />
This chapter shows the procedures for installing and starting the <strong>Prestige</strong>.<br />
The <strong>Prestige</strong> provides LEDs as status indicator for diagnostics purpose. The following figure and table describe the functions of<br />
LEDs on the front panel of <strong>Prestige</strong>:<br />
Figure 2-1 <strong>Prestige</strong> <strong>964</strong> front panel<br />
Table 2-1 <strong>Prestige</strong> <strong>964</strong> LED Functions<br />
FUNCTION NAMING COLOR LED DESCRIPTION<br />
Power PWR Green On: Power On<br />
Off: Power Off<br />
System SYS Green<br />
or<br />
Orange<br />
On (Green): System ready and running successfully<br />
On (Orange): System is loading the configuration<br />
Flashing (Green): System rebooting<br />
Off: System not ready<br />
LAN<br />
link/activity<br />
LAN 1~5<br />
Green (10M)<br />
or<br />
On: LAN 1~5 Ethernet port link successful<br />
Flashing: LAN 1~5 is Sending or Receiving<br />
Orange (100M)<br />
Off: LAN 1~5 Ethernet port not ready<br />
USB USB Green On: USB link successful<br />
Flashing: Sending or Receiving<br />
Off: USB not ready<br />
<strong>Cable</strong> data<br />
activity<br />
<strong>Cable</strong> link<br />
status<br />
DATA Green Flashing: WAN port (<strong>Cable</strong> Interface) TX/RX<br />
Off: Connection is idle<br />
CABLE Green On: The <strong>Prestige</strong> is registered successfully with <strong>Cable</strong> Modem<br />
Terminal System (CMTS)<br />
Slow Flash (2 seconds interval): The <strong>Prestige</strong> is scanning<br />
downstream channel<br />
Fast Flash (1 second interval): The <strong>Prestige</strong> is locked on to<br />
downstream channel and is ranging and registering with CMTS<br />
The SYS LED is always GREEN while system is ready or rebooting. The SYS LED will become ORANGE when the system is<br />
loading its configuration. Don’t power off or reset your <strong>Prestige</strong> during the SYS LED is becoming ORANGE can only do so<br />
after the SYS LED returns GREEN. Otherwise, your <strong>Prestige</strong> will not work properly anymore.<br />
The next figure shows the rear panel of your <strong>Prestige</strong> and the connection diagram.<br />
Hardware Installation 2-1