Prestige 964 Cable Router Operator's Guide - bei GGA Maur

Prestige 964 Cable Router
HTTP User ID = 'user'
HTTP User Password = '1234'
HTTP Admin ID = 'webadmin'
HTTP Admin Password = '1234'
Telnet Enable = true
Telnet Admin ID = 'admin'
Telnet Admin Password = '1234'
TACACS+ Enable = false
6.4.5 dload –s [IP address] [firmware_file]
This command is used to upgrade the firmware of Prestige cable router from the LAN side. The “firmware_file” is the parameter of
firmware name. The filename is usually the model name with a *.img extension, e.g., P964CR.img. To upgrade firmware for Prestige,
follow the steps:
1. Configure PC’s IP address as 192.168.100.2
2. Run TFTP server on the PC and put “P964CR.img” into the outbound directory where the “P964CR.img” is the firmware
name.
3. Telnet the Prestige cable router using user name and password.
4. Enter “cd docsis_ctl” to get into docsis_ctl directory
5. Use “scan_stop” command to bypass the downstream scanning procedure if without headend CMTS.
6. Use “dload –s 192.168.100.2 P964CR.img” to start upgrade.
6.5 Other Commands
6.5.1 reset
This command is to resets the system (warm boot).
Example:
reset
6.5.2 bootdelay [ true | false ]
In some environment the CMTS can not sense that CM is rebooting. Use this command to let CMTS has much more time to know
that CM is rebooting.
Example:
bootdelay true
6.5.3 logout
For Telnet clients, this lets the user log out cleanly.
Example:
logout
6.5.4 version
Display the current firmware version.
6.5.5 arpShow
Displays current arp table information.
Example:
CM> arpShow
LINK LEVEL ARP TABLE
destination gateway flags Refcnt Use Interface
--------------------------------------------------------------------------------------------
10.11.255.254 00:50:54:68:a8:38 405 0 0 bcm0
192.168.100.254 00:10:18:ff:ff:ff c05 0 0 bcm1
--------------------------------------------------------------------------------------------
6.5.6 ifShow
Displays current interface information.
Example:
6-6 Command Sets