SMA 3300/3800 Manual - All Eco Energy
SMA 3300/3800 Manual - All Eco Energy
SMA 3300/3800 Manual - All Eco Energy
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>SMA</strong> Solar Technology AG<br />
Maintenance and Cleaning<br />
8 Maintenance and Cleaning<br />
Check for proper inverter operation at regular intervals. Impurities such as dust or airborne blossoms<br />
can cause heat concentration that can lead to yield losses. Also check the inverter and the cables for<br />
visible external damage. Undertake repairs if necessary.<br />
8.1 Checking Heat Dissipation<br />
You only need to check the heat dissipation of the inverter if, during a visual inspection, you notice a<br />
marked build-up in the fan grill or the inverter is increasingly observed to be in derating mode.<br />
Whether the inverter switches to derating mode depends on the ambient temperature and cooling<br />
efficiency.<br />
8.1.1 Cleaning the Fan<br />
If the fan grill is only covered in loose dust it can be cleaned with a vacuum cleaner. If you do not<br />
achieve satisfactory results with a vacuum cleaner, dismantle the fans for cleaning.<br />
Proceed as follows:<br />
1. Disconnect the inverter from both the DC and AC connections, as described in section<br />
7.2 ”Opening the Inverter” (page 37).<br />
2. Wait for the fan to stop rotating.<br />
Cleaning the Fan Grills<br />
3. Remove the fan grill:<br />
– Press the two latches on the right edge of the fan<br />
grill to the right using a screwdriver and loosen<br />
it from the bracket.<br />
– Carefully remove the fan grill.<br />
4. Clean the fan grill with a soft brush, a paint brush,<br />
a cloth or pressurized air.<br />
Cleaning the Fan<br />
5. Push the two upper plastic clips backward and the<br />
lower plastic clip forward.<br />
6. Remove the fan by pulling it slowly and carefully<br />
downward.<br />
7. Unlock and unplug the fan plug inside the inverter.<br />
The fan cables are long enough that you can lift the fan far enough out to disconnect the internal<br />
plug connector in the inverter.<br />
Installation Guide SB33_38-IEN100540 41