FELCOM 15 - Yachtronics

4. INMARSAT C COMMUNICATIONS
13. Press the [Enter] key to open the confirmation window.
14. To request notification of delivery from the LES, choose ON. If not necessary
choose OFF.
15. Press the [Enter] key to close the window.
16. Press the [↓] key to choose Send Delay.
17. Press the [Enter] key to open the send delay entry window.
18. To send a message after a certain delay, enter a time up to 99 hours 59
minutes. (The Send Delay is used to time message arrival to suit recipient’s
office hours.)
19. Press the [Enter] key to close the window.
20. Press the [↓] key to choose Delivery Delay.
21. Press the [Enter] key to open the delivery delay options window.
22. Delivery Delay requests the LES for “Immediate” or “Deferred” transmission
to the recipient designated. Press the [↑] or [↓] key to choose Immediate or
Deferred. For information on this service, consult with LES where message is
to be sent.
23. Press the [Enter] key to close the window.
24. Press the [↓] key to choose Code and press the [Enter] key.
25. Press the [↑] or [↓] key to choose “IA5 (for e-mail, fax) ”, “ITA2 (for telex)”
“DATA” or “SMS” as appropriate.
26. Press the [Enter] key to close the window.
27. Press the [↓] key to place the cursor on TRANSMIT.
28. Press the [Enter] key to open the start window.
Date
97-08-04 Transmit Message BBER
Time Priority
Message File
01:32 (UTC) Normal
SEISETU.TXT
C/N
Send level Size 46
Position Station Name LAT FURUNO RxIF AGC Cost ********.** Level (US$)
Destination Type LON TELEX
REF Offset Freq
Waypoint Prefix Code LAT
Synthe 1st local
Country/Ocean Code LON
Course Station ID
Speed Modem Type
81
321 DEG
KTS
3rd local
Synthesizer
TX2nd Local
Current Address NCS
Current Subject Channel
Current Attach TDM File
344 (IOR) LOGOUT
NCS CC
NCS CC
Antenna Power Supply
Water Temperature
MES LES Status ID
GPS Option Status
Idle
****
303 (KDDI) Water Current
Direction
Start
Confirmation ON
Speed Yes No
DCE Send Memory Delay
Delivery Delay
Code
[ TRANSMIT ]
3281800:00
Bytes free
Immediate
IA5
Depth
Transmit message screen
29. Press the [Enter] key to send the message to the message queue. (To
escape, choose “No” and press the [Enter] key.) The message “Message is
entered in sending Queue. Press any key.” appears.
Note 1: If some data has not been entered, the message “Input Error: xx.”
(xx: error content) appears.
Note 2: When you send a message which contains more than 32 KB of data,
the message “Message file is too large (but sent only with 32 KB).”
4-6