920i Installation manual - Rice Lake Weighing Systems
920i Installation manual - Rice Lake Weighing Systems
920i Installation manual - Rice Lake Weighing Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2.4 Installing Option Cards<br />
Each option card is shipped with installation<br />
instructions specific to that card. The general<br />
procedure for all option cards is as follows:<br />
Option cards are not hot-pluggable.<br />
Disconnect power to the <strong>920i</strong> before<br />
installing option cards.<br />
1. Disconnect power to the indicator. Remove<br />
backplate as described in Section 2.2 on<br />
page 10.<br />
2. Carefully align the large option card connector<br />
with connector J5 or J6 on the CPU board (see<br />
Figure 2-9). Press down to seat the option card<br />
in the CPU board connector.<br />
3. Use the screws provided in the option kit to<br />
secure the other end of the option card to the<br />
threaded standoffs on the CPU board (see<br />
Figure 2-9).<br />
4. Make connections to the option card as required.<br />
Use cable ties to secure loose cables inside the<br />
enclosure as shown in Figure 2-10. When<br />
installation is complete, reassemble the<br />
enclosure as described in Section 2.6 on<br />
page 17.<br />
CT INDICATES<br />
OPTION CARD<br />
CABLE TIES<br />
CT<br />
CT<br />
PULSE INPUT<br />
CARD<br />
CT<br />
DUAL A/D<br />
CARD<br />
Memory Card<br />
Figure 2-10. Installed Option Cards, Showing Secured<br />
Cables<br />
The <strong>920i</strong> automatically recognizes all installed option<br />
cards when the unit is powered on. No<br />
hardware-specific configuration is required to identify<br />
the newly-installed card to the system.<br />
CT<br />
J5<br />
J6<br />
Figure 2-9. Installing Option Card Onto CPU Board<br />
<strong>Installation</strong> 15