P-51B Mustang 32e ARF Manual - Horizon Hobby
P-51B Mustang 32e ARF Manual - Horizon Hobby
P-51B Mustang 32e ARF Manual - Horizon Hobby
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
15. Slide the rudder pushrod into the tube in the<br />
fuselage. The pushrod from the tail wheel will slide<br />
into the brass pushrod connector. Secure the servo<br />
horn to the rudder servo using the screw removed in<br />
Step 1 and a #1 Phillips screwdriver.<br />
<br />
17. Repeat Step 16 for the remaining elevator.<br />
Make sure the elevators are aligned in the same<br />
position by viewing the aircraft from the rear. If they<br />
are not aligned, you may have difficulty trimming<br />
your model for straight and level flight.<br />
<br />
19. Center the tail wheel so your model will<br />
taxi straight down the runway. Use a #1 Phillips<br />
screwdriver and a 3mm x 4mm machine screw to<br />
secure the pushrod from the tail wheel to the brass<br />
pushrod connector.<br />
16. Slide a clevis retainer on a nylon clevis.<br />
Thread the clevis on the elevator pushrod wire.<br />
When the connector is attached to the outside hole<br />
on the elevator control horn, the elevator should be<br />
centered with the elevator servo centered. Adjust<br />
the position of the clevis as necessary to align the<br />
elevator in the neutral position. Once set, slide the<br />
silicone retainer over the forks of the clevis so the<br />
clevis does not open accidentally in flight.<br />
<br />
18. Repeat Step 16 to connect the rudder linkage to<br />
the rudder control horn.<br />
<br />
20. Turn off the switch at the speed control, then<br />
turn off the transmitter. Unplug the motor battery<br />
from the speed control.<br />
Always use threadlock on metal-to-metal fasteners<br />
to prevent them from vibrating loose.<br />
E-flite P-<strong>51B</strong> <strong>Mustang</strong> <strong>32e</strong> <strong>ARF</strong> Assembly <strong>Manual</strong><br />
17