P-51B Mustang 32e ARF Manual - Horizon Hobby
P-51B Mustang 32e ARF Manual - Horizon Hobby
P-51B Mustang 32e ARF Manual - Horizon Hobby
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4. Remove the servo horn from the servo. Use<br />
side cutters to remove the arms from the horn that<br />
were not marked in the previous step. Enlarge the<br />
hole in the servo horn that is 7/16-inch (11mm)<br />
from the center of the horn using a pin vise and<br />
5/64-inch drill bit.<br />
6. Apply 2–3 drops of thin CA in each of the<br />
mounting holes for the servo screws. This will<br />
harden the wood and help prevent the screws from<br />
vibrating loose.<br />
8. Slide a silicone clevis retainer over a nylon clevis.<br />
Thread the clevis 10-turns on the 3-inch (76mm)<br />
pushrod wire.<br />
5. Attach the servo horn to the servo using the screw<br />
removed from the servo and a #1 Phillips screwdriver.<br />
7. Mount the aileron servo using the four screws<br />
provided with the servo and a #1 Phillips screwdriver.<br />
9. Deflect the flap. Insert the linkage in the hole at<br />
the trailing edge of the wing near the flap control<br />
horn. Attach the clevis to the flap control horn.<br />
Slide the silicone retainer over the forks of the<br />
clevis to prevent it from opening accidentally. The<br />
overall length of the linkage will be adjusted in the<br />
next steps.<br />
E-flite P-<strong>51B</strong> <strong>Mustang</strong> <strong>32e</strong> <strong>ARF</strong> Assembly <strong>Manual</strong><br />
23