P-51B Mustang 32e ARF Manual - Horizon Hobby
P-51B Mustang 32e ARF Manual - Horizon Hobby
P-51B Mustang 32e ARF Manual - Horizon Hobby
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
15. Use four 2mm x 8mm sheet metal screws with<br />
shoulder and a #1 Phillips screwdriver to secure the<br />
flap servo cover to the wing. You can remove the<br />
mark made earlier when the cover was removed<br />
using rubbing alcohol and a paper towel.<br />
17. Set the flap switch (or knob) to the DOWN<br />
position. Use the endpoint adjustment to set the<br />
distance between the wing trailing edge and flap so<br />
it measures 1 5 / 8 -inch (41mm).<br />
Fixed Gear Installation<br />
Required Parts<br />
Wing panel (right and left)<br />
Main gear strut (right and left)<br />
Main gear wheel, 2 1 / 2 -inch (63mm) (2)<br />
Main gear strut mount with setscrew (2)<br />
Wheel collar with setscrew (4)<br />
3mm x 8mm sheet metal screw (8)<br />
Required Tools and Adhesives<br />
Hex wrench: 1.5mm<br />
Phillips screwdriver: #2<br />
Threadlock<br />
16. Set the flap switch (or knob) to the UP position.<br />
Use the endpoint adjustment to align the flap with<br />
the trailing edge of the wing. You will want to make<br />
sure both flaps sit up without binding by adjusting<br />
the clevis. This will help to ensure they throw the<br />
same amount when going down.<br />
<br />
18. Repeat Steps 1 through 17 to install the<br />
remaining aileron servo and linkage.<br />
When installing the remaining flap servo, start with<br />
the flap and flap servo in the UP position (using the<br />
transmitter) to set the correct length for the linkage. This<br />
will avoid stalling the servo if the linkage is too short.<br />
<br />
Always use threadlock on metal-to-metal fasteners<br />
to prevent them from vibrating loose.<br />
1. Insert the main gear strut into the main gear strut<br />
mount. Use a #2 Phillips screwdriver to tighten the<br />
setscrew on the flat area of the main gear strut.<br />
Assemble the right and left main gear at this time.<br />
<br />
19. Remove the string from the flap and aileron<br />
leads. Mark the flap lead using low-tack tape. Make<br />
sure your radio system has been turned off as to not<br />
run the batteries down.<br />
Note: The included fixed gear will differ slightly<br />
from what is shown.<br />
E-flite P-<strong>51B</strong> <strong>Mustang</strong> <strong>32e</strong> <strong>ARF</strong> Assembly <strong>Manual</strong><br />
25