condair cP3 D

43
– Wochen Timer: With the settings in the submenu “Week Timer” you can configure the
week timer for the time controlled operation of the steam generator.
Note: This menu item is available only if the operating mode (see previous
menu item “Operation”) is set to “WeekTime”.
– Week timer deactivated:
Week Timer
Timer :Off
Event 1 :18:00
Event 2 :19:00
Event 3 :--:--
Event 4 :--:--
Esc
Set
– Week timer activated:
Week Timer
Timer :On
Event 1 :18:00
Event 2 :19:00
Event 3 :--:--
Event 4 :--:--
Esc
Set
Event 1
Weekday :Mo-Fr
Time :18:00
Steam Bath :On
Esc
Set
If the timer is activated, up to eight switching
points (events 1 - 8) can be defined to switch
the steam generator On or Off.
Each switching point is defined by a weekday
or weekday range, the switching point and
the desired operating status of the steam
generator.
Configuration notes:
– the settings of an event remain active up to the next event.
– the software does not check the plausibility of the timer settings.
Therefore, make sure your settings make sense.
– Fan: With the settings in the submenu “Fan” you can determine the operating
mode of the fan as well as the post-operational time of the fan for drying
the steam bath cabin.
Fan
Mode
:3 Stages
Drying Time :20min
Esc
Set
– Mode: Setting the operating mode of the fan.
Factory setting:
Options:
3 Stages
3 Stages (Operation of the fan with three
performance levels 15/18/24VAC, which are
controlled in dependency of the temperature
in the steam bath cabin)
1 Stage (Operation of the fan with only one
performance level 24VAC)
Off (Fan off)
– Drying time: Setting the post-operational time of the fan for
drying the steam bath cabin.
Factory setting:
Setting range:
20 min
1 ... 60 min