KR 60 L30 JET - KUKA Robotics
KR 60 L30 JET - KUKA Robotics
KR 60 L30 JET - KUKA Robotics
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>KR</strong> <strong>60</strong> <strong>L30</strong> <strong>JET</strong><br />
Fig. 6-2: Mounting base with bedplate, dimensioned drawing<br />
1 Center of foundation<br />
2 Bedplate<br />
3 Concrete foundation<br />
Fastening to<br />
mounting base<br />
The mounting base (>>> Fig. 6-3 ) consists of:<br />
• Leveling screw (2)<br />
• Baseplate (5)<br />
• Resin-bonded anchors (4)<br />
• Fasteners (1)<br />
The leveling screws (2) are screwed through the columns (3). They are supported<br />
via the baseplates (5) on the foundation. After alignment of the gantry,<br />
the components are fastened together with screws and the leveling screws are<br />
welded to the foundation.<br />
This mounting base requires a level and smooth surface on a concrete foundation<br />
with adequate load bearing capacity. The minimum dimensions must<br />
be observed.<br />
38 / 55 Issued: 08.07.2013 Version: Spez <strong>KR</strong> <strong>60</strong> <strong>L30</strong> <strong>JET</strong> V4 en (PDF)