SONAbeam -E Series Installation Manual
SONAbeam -E Series Installation Manual
SONAbeam -E Series Installation Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Installing Your <strong>SONAbeam</strong> Terminal<br />
Optional Customer Cabling Kit<br />
An optional E-<strong>Series</strong> Cabling Kit is available from fSONA, which provides all of the<br />
components necessary to interface a <strong>SONAbeam</strong> to a suitably located Customer Interface<br />
Box. This optional kit includes:<br />
ONE – 2.25m length of 1” Liquid-Tight flexible conduit, with 1” conduit<br />
connector kit…<br />
<br />
<br />
<br />
<br />
ONE – 2.5m length of 3-18 AWG power cable…<br />
TWO – 3m CAT5 patch cable with RJ45 terminated ends…<br />
TWO – 2.5m multimode duplex fiber optic cable with SC terminated ends…<br />
TWO – 2.5m single mode duplex fiber optic cable with SC terminated ends…<br />
WARNING!<br />
If you choose to provide your own interface components, the conduit must<br />
provide a watertight interface to the terminal.<br />
For powering your <strong>SONAbeam</strong> terminals, use standard, compliant power<br />
cordage that meets or exceeds the following:<br />
18 – 14 AWG stranded; 300 Volts; -40°C to 85°C<br />
In extreme environments, select suitably rated power cordage!<br />
Furthermore, all applicable local/regional safety codes MUST be observed!<br />
<strong>SONAbeam</strong> Customer Interface Area<br />
All of the customer-provided interfaces are made in the <strong>SONAbeam</strong> terminal’s Customer<br />
Interface Area inside the optical head through the customer-provided, 1” flexible Liquid-<br />
Tight conduit.<br />
To remove the cover to the Customer Interface Area:<br />
1. Using a 5mm Allen wrench – one is provided in<br />
the optional Basic Alignment Kit – loosen the<br />
four cover screws shown in Figure 10…<br />
<strong>SONAbeam</strong> E-<strong>Series</strong> <strong>Installation</strong> <strong>Manual</strong><br />
NOTE…<br />
Figure 10 – <strong>SONAbeam</strong> Customer<br />
Interface Cover Screws<br />
The four Customer Interface Cover screws are captive and the cover itself is<br />
tethered to the optical head…<br />
30 wireless at the speed of light …………….