Troubleshooting Windows Deployments 2012-09-11 - TechNet Blogs
Troubleshooting Windows Deployments 2012-09-11 - TechNet Blogs
Troubleshooting Windows Deployments 2012-09-11 - TechNet Blogs
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
7102 ZTIConfigureADDS.wsf ERROR - Mandatory properties for<br />
creating a new replica DC were not<br />
specified<br />
7103 ZTIConfigureADDS.wsf ERROR - Mandatory properties for<br />
creating a new child domain were not<br />
specified<br />
7104 ZTIConfigureADDS.wsf ERROR - Mandatory properties for<br />
creating a new forest were not specified<br />
7105 ZTIConfigureADDS.wsf ERROR - Mandatory properties for<br />
creating a new forest were not specified<br />
7200 ZTIConfigureDHCP.wsf Unable to configure DHCP Server<br />
because the service is not installed.<br />
7201 ZTIConfigureDHCP.wsf Unable to read the Scope Details -<br />
GetScopeDetails() failed<br />
task sequence editor, but if you tried to run<br />
ZTIConfigureADDS.wsf yourself without setting the<br />
ReplicaOrNewDomain task sequence variable<br />
properly, you would get this error.<br />
1 4 Same as above, but in this case you didn’t set one<br />
of these variables:<br />
ReplicaDomainDNSName<br />
ADDSUserName<br />
ADDSPassword<br />
ADDSUserDomain<br />
1 4 Same as above, but in this case you didn’t set one<br />
of these variables as needed:<br />
ChildName<br />
ParentDomainDNSName<br />
ADDSUserName<br />
ADDSPassword<br />
ADDSUserDomain<br />
1 4 Same as above, but in this case the<br />
NewDomainDNSName task sequence variable<br />
wasn’t set.<br />
1 4 Same as above, but in this case you didn’t set one<br />
of these variables:<br />
NewDomainDNSName<br />
ADDSUserName<br />
ADDSPassword<br />
ADDSUserDomain<br />
2 10 You added a step to “Configure DHCP” to the task<br />
sequence, but when the step ran it found that the<br />
DHCP Server wasn’t installed. You would need to<br />
first install it using an “Install Roles and Features”<br />
step.<br />
1 5 Normally you would configure the DHCP scope<br />
details through the task sequence UI, but if you ran<br />
ZTIConfigureDHCP.wsf manually and didn’t specify<br />
Page | 14