NAT-MCH Users Manual Version 1.10

NAT-MCH – Users Manual
imsg_info IPMI message information
Prints the implementation status for the supported IPMI
messages on the Host (RMCP) interface and can be used to
print a list of IPMI messages that are supported by the MCH.
sdrrep_info SDR repository information
Prints an overview about the Sensor Data Repository of the
MCH.
sel_info System Event Log information
Prints the Sensor Event Log status and stored events in raw
and decoded format.
session_info Session information
Print status about currently active sessions.
show_ekey Show all activated connections
show_fru Show all FRUs
show_fruinfo fru_id FRU contents
Shows the contents of a FRU device referred to by .
For valid FRU numbers please refer to MTCA R1.0 table 3-
3.
show_pm Power Module Status
Shows the actual power allocation status for all AMC
modules and Cooling Units.
show_sensorinfo fru_id Show sensors for FRU
version Print firmware version information
ping IP address Issue ICMP echo request
This command supports some command line options. For
more information on the command’s usage try ‘ping -?’.
route -? Modify routing tables
This command can be used to manually modify the IP
routing tables. If called without any parameters it prints the
current routing table entries. For more information on the
command’s usage try ‘route -?’.
Warning: Only change the routing table entries if you
know what you are doing. Changing the
routing table configuration may lead to loss
of network connection to the MCH.
vlanp_cfg Port based VLAN configuration
vlanq_cfg 802.1Q VLAN protocol configuration
vlanx_cfg 802.1x VLAN security protocol configuration
qos_cfg Quality of service menu:
802.1p: priority protocol configuration
diag Menu driven diagnostic tool – service personal only
fan_ctl FAN control
Command to get fan properties and speed level and to set the
fan speed level.
Version 1.10 © N.A.T. GmbH 40