NAT-MCH Users Manual Version 1.10

NAT-MCH – Users Manual
9 Webserver
The NAT-MCH has an integrated embedded webserver which allows users to view and
change configuration parameters of the NAT-MCH.
Before the webserver can be used it has to be enabled via the command line interface using
the mmch command (see Chapter 5.4).
The onboard webserver can be accessed with any standard web browser by entering the IPaddress
of the management port of the NAT-MCH into the browser’s address line. After the
web browser has connected to the onboard webserver, the user is asked to enter a username
and the associated password. The default values for these are:
Username: root
Password: nat
The functions supported by the webserver may vary with new firmware releases. Currently
the following functions are supported.
Function Sub Functions Description
Show MCH
- Shows the NAT-MCH Configuration similar to
Configuration
the command line interface command mch.
Change MCH
- Provides a graphical configuration menu to
Configuration
change the basic configuration of the NAT-MCH
similar to the command line interface command
mmch.
Port based
- Provides a graphical configuration menu to
VLAN Settings
change the port based VLAN settings. For more
details please refer to the VLAN manual.
download binary Use this item to store the current port based
configuration file VLAN settings as a binary file at the selected
location.
Upload binary Use this item to upload a file containing a binary
configuration file coded port based VLAN configuration from the
selected location.
802.1q based
Provides a graphical configuration menu to
VLAN Settings
change the 802.1q based VLAN settings. For
more details please refer to the VLAN manual.
Add VLAN Use this item to add a new VLAN group in the
Group range of 1 – 4094.
Remove VLAN Use this item to display all existing VLAN
Group groups and to select a specific group to be
deleted.
Version 1.10 © N.A.T. GmbH 42