NAT-MCH Users Manual Version 1.10
NAT-MCH Users Manual Version 1.10
NAT-MCH Users Manual Version 1.10
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>NAT</strong>-<strong>MCH</strong> – <strong>Users</strong> <strong>Manual</strong><br />
Appendix A 3 Ethernet Connector – 100 BaseT Management Port<br />
The following table shows the pin assignment of RJ45 that carries the 100BaseT<br />
signals of the Ethernet interface of the ColdFire. Termination is the 100BaseT<br />
termination used for pins 4, 5, 7, and 8.<br />
Pin No.<br />
Signal Signal Pin No.<br />
1 TX+ TX- 2<br />
3 RX+ Term. 4<br />
5 Term. RX- 6<br />
7 Term. Term. 8<br />
Table 6 Pin Assignment of the Front-panel Connector (100 BaseT)<br />
Appendix A 4 External Clock Reference Connector<br />
The following table shows the pin assignment of the signals of the external reference<br />
clock interface.<br />
Pin No.<br />
Signal Signal Pin No.<br />
Center EXTREF_P EXTREF_N Shield<br />
Table 7 Pin Assignment of the Clock Connector S3<br />
<strong>Version</strong> <strong>1.10</strong> © N.A.T. GmbH 48
Change language