2009 Fox Racing Shox Owner's Manual - Bike-Components

More documents

Recommendations

Info

36 VAN RC2 & R weight travel features/adjustments RC2 features/adjustments spring/damper type intended use RC2: 5.21 lbs. / 2.36 kg R: 5.12 lbs. / 2.32 kg 6.3 in. / 160 mm low-speed compression, high-speed compression, hydraulic bottom-out in damper, coil spring preload, rebound hydraulic bottom-out in damper, coil spring preload, rebound steel spring/RC2 FIT damper downhill, all-mountain, freeride Fox Racing Shox 2009 Owners Manual 36 VAN RC2 & R Page 155
Installing Your Fork Be sure your fork is properly installed before proceeding. If your fork came pre-installed on your bicycle, continue to the next section, otherwise see “Installing a 36 mm Fork” on page 129. Before You Ride 1. Check that the 20 mm axle pinch bolts and crown pinch bolts are properly adjusted and tightened. 2. Clean the outside of your fork with soap and water and wipe dry with a soft dry rag. Do not spray water directly on the seal/upper tube junction. Caution: Do not use a high pressure washer on your fork. 3. Inspect entire exterior of fork for damage. The fork should not be used if any of the exterior parts appear to be damaged. Please contact your local dealer or FOX Racing Shox for further inspection and repair; see “Contact FOX” on page 321. 4. Check headset adjustment. If loose, adjust according to manufacturer’s recommendations. 5. Check that brake cables or hoses are properly fastened. 6. Check that the front and rear brakes operate properly on flat land. Setting Sag To get the best performance from your fork, it is necessary to set and adjust sag. Generally, sag should be set to 15 – 25% of total fork travel. 1. Install a zip tie with light friction on the upper tube and push it down until it contacts the fork seal. 2. Carefully sit on the bike and assume a normal riding position. The fork should compress slightly. 3. Being careful not to further compress the fork, dismount the bicycle. Measure the distance between the seal and the zip tie. This distance is sag. 4. Compare your sag measurement to the Sag Setup table below. If sag is lower than in the table, turn the preload knob (shown below) counter-clockwise one (1) full turn. Measure sag again and repeat adjustment if necessary. If sag is higher than in the table, turn the preload knob clockwise one (1) full turn. Measure sag again and repeat adjustment if necessary. If correct sag cannot be achieved by adjusting the preload knob, see the 36 Van Coil Spring Setting Guidelines table below. You may need to change to a coil spring with a different spring rate. Fox Racing Shox 2009 Owners Manual 36 VAN RC2 & R Page 156
Page 1 and 2:
2009 Fox Racing Shox Owner’s Manu
Page 3 and 4:
Adjusting Rebound .................
Page 5 and 6:
Installing Your Fork ..............
Page 7 and 8:
Changing Springs ..................
Page 9 and 10:
32 TALAS RL (OE Edition) ..........
Page 11 and 12:
Welcome to FOX Racing Shox & FOX- H
Page 13 and 14:
Forks • Verify that the brakes on
Page 15 and 16:
Rear Shocks • If the shock ever l
Page 17 and 18:
Installing a 32 mm Fork Note: This
Page 19 and 20:
Brakes Linear-pull Linear-pull brak
Page 21 and 22:
Caution: Torque calipers to brake m
Page 23 and 24:
Warning! Do not use a tire if any m
Page 25 and 26:
1. Position your front wheel into t
Page 27 and 28:
Figure 4: 15QR Lever Resistance Poi
Page 29 and 30:
15QR Axle Lever Cam Tension Adjustm
Page 31 and 32:
8. To safely secure your front whee
Page 33 and 34:
32 FLOAT RLC weight travel 3.74 lbs
Page 35 and 36:
6. Being careful not to further com
Page 37 and 38:
6 (Factory setting) Average Rebound
Page 39 and 40:
5 (Factory setting) Average Compres
Page 41 and 42:
Travel Spacer Orientation Seal Orie
Page 43 and 44:
Installing Your Fork Be sure your f
Page 45 and 46:
Sag Troubleshooting Symptom Too muc
Page 47 and 48:
• Torque wrench • Oil drain pan
Page 49 and 50:
Seal Orientation Be sure that the l
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
1 803-00-078 32 mm Cartridge Seal K
Page 57 and 58:
F29 120 RLC, F29 100 RLC, F29 80 RL
Page 59 and 60:
5. Carefully sit on the bike and as
Page 61 and 62:
Knob Setting (CLICKS OUT FROM FULL
Page 63 and 64:
Knob Setting (CLICKS IN FROM FULL O
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Turn the knob clockwise to increase
Page 71 and 72:
32 F120 RL, F100RL, F80RL weight tr
Page 73 and 74:
Page 75 and 76:
6 Average Rebound (Factory setting)
Page 77 and 78:
Installing Your Fork (See “32 Rem
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
32 Remote RL Fork Setup Guide Figur
Page 85 and 86:
Figure 3: Positioning the Shimano L
Page 87 and 88:
Figure 6: Actuation Lever and Thumb
Page 89 and 90:
32 F120 R, F100R, F80R weight trave
Page 91 and 92:
Page 93 and 94:
6 Average Rebound (Factory setting)
Page 95 and 96:
Page 97 and 98:
Note: Sag and spring rate will self
Page 99 and 100:
Page 101 and 102:
32 TALAS RL weight travel features/
Page 103 and 104:
4. Install a zip tie with light fri
Page 105 and 106: KNOB SETTING (CLICKS OUT FROM FULL
Page 107 and 108: 32 TALAS R weight travel features/a
Page 109 and 110: 4. Install a zip tie with light fri
Page 111 and 112: KNOB SET- TING (CLICKS OUT FROM FUL
Page 113 and 114: 32 Vanilla RLC weight travel featur
Page 115 and 116: Vanilla Coil Spring Setting Guideli
Page 117 and 118: Locking Out the Fork The blue compr
Page 119 and 120: 9 Firm Compression Too firm and you
Page 121 and 122: Installing Your Fork Be sure your f
Page 123 and 124: Adjusting Rebound The rebound knob
Page 125 and 126: 32 Vanilla R weight travel features
Page 127 and 128: Vanilla Coil Spring Setting Guideli
Page 129 and 130: 3. Wipe the spring dry with a rag a
Page 131 and 132: 11. Using a crown race setter to in
Page 133 and 134: The 36 is designed for use with dis
Page 135 and 136: Fox Racing Shox 2009 Owners Manual
Page 137 and 138: 2. Thread the axle in until hand ti
Page 139 and 140: 4. Close both QR Levers by rotating
Page 141 and 142: Installing Your Fork Be sure your f
Page 143 and 144: Sag Troubleshooting Symptom Too muc
Page 145 and 146: Adjusting Low-Speed Compression (RC
Page 147 and 148: 4. Pull the air-shaft assembly from
Page 149 and 150: 36 TALAS RC2 & R weight travel feat
Page 151 and 152: 4. Using the 36 TALAS Air Spring Se
Page 153 and 154: 1 Slow Rebound Too slow and your fo
Page 155: Hydraulic Bottom-Out System The 36
Page 159 and 160: Harsh ride; full travel not utilize
Page 161 and 162: Adjusting Low-Speed Compression (RC
Page 163 and 164: Installing a 40 mm Fork 1. Verifyin
Page 165 and 166: Caution: Fox Racing Shox does not m
Page 167 and 168: Figure 4: 40 Upper Crown Installati
Page 169 and 170: 7. Installing the Front Wheel: Figu
Page 171 and 172: . Depending on the shape and size o
Page 173 and 174: 40 RC2 weight travel features/adjus
Page 175 and 176: 40 Coil Spring Settings FOX Part #
Page 177 and 178: Adjusting High-Speed Compression (R
Page 179 and 180: 2. Remove the black spring spacers
Page 181 and 182: ment in the fork or if it makes str
Page 183 and 184: 18. Slide the lower leg down furthe
Page 185 and 186: 3. Cut two four-inch (100 mm) strip
Page 187 and 188: 7. Pour a small amount of suspensio
Page 189 and 190: 11. Apply FLOAT Fluid to the foam r
Page 191 and 192: 15. If you cannot push the seal in
Page 193 and 194: Oil Volumes - Forks 2002-2009 Fork
Page 195 and 196: 2003-2006 TALAS 125 & 130 (R, RL, R
Page 197 and 198: 2009+ 36 TALAS III (R and RC2 dampe
Page 199 and 200: General Maintenance There may be a
Page 201 and 202: Adjusting the ProPedal Switch The P
Page 203 and 204: DHX Air 4.0 weight 0.94 lbs. / 429
Page 205 and 206: 6. Repeat steps 2-5 until proper sa
Page 207 and 208:
• For a softer ride, decrease the
Page 209 and 210:
5. Pressurize your main air chamber
Page 211 and 212:
Boost Valve The Boost Valve creates
Page 213 and 214:
General Maintenance Some things to
Page 215 and 216:
Reading Your Spring Rate Adjusting
Page 217 and 218:
Note: If the knob feels gritty duri
Page 219 and 220:
Page 221 and 222:
Reading Your Spring Rate Adjusting
Page 223 and 224:
For a softer ride, decrease the sho
Page 225 and 226:
Page 227 and 228:
spring orientation. Correct spring
Page 229 and 230:
VAN R weight 0.74 lbs. / 339 g (8.7
Page 231 and 232:
Note: If after the preload ring eng
Page 233 and 234:
ProPedal The ProPedal on your VAN R
Page 235 and 236:
General Maintenance There may be a
Page 237 and 238:
• OPEN • PROPEDAL Use each sett
Page 239 and 240:
FLOAT RP2 weight features/ adjustme
Page 241 and 242:
6. Repeat steps 2-5 until proper sa
Page 243 and 244:
FLOAT R (rear shock) weight 0.44 lb
Page 245 and 246:
Air Spring Setting Guidelines Shock
Page 247 and 248:
Measuring Sag In general, sag on yo
Page 249 and 250:
"Stuck Down" Shock Procedure Under
Page 251 and 252:
emove wire rings and air sleeves. C
Page 253 and 254:
15. When replacing the air sleeve w
Page 255 and 256:
OE Custom Products These products a
Page 257 and 258:
General Maintenance There may be a
Page 259 and 260:
Adjusting Compression Some bicycles
Page 261 and 262:
32 TALAS RLC (OE Edition) weight tr
Page 263 and 264:
6. Being careful not to further com
Page 265 and 266:
6 (Factory setting) Average Rebound
Page 267 and 268:
5 (Factory setting) Average Compres
Page 269 and 270:
32 TALAS RL (OE Edition) weight tra
Page 271 and 272:
3. Using the Air Spring Settings ta
Page 273 and 274:
1 Slow Rebound Too slow and your fo
Page 275 and 276:
For safety reasons, it is recommend
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
32 F90 RL (OE Edition) weight trave
Page 285 and 286:
7. Compare your sag measurement to
Page 287 and 288:
12 Fast Rebound Too fast and you wi
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
F29 100 RL & F29 80 RL (OE Edition)
Page 299 and 300:
7. Compare your sag measurement to
Page 301 and 302:
12 Fast Rebound Too fast and you wi
Page 303 and 304:
14. Youre done. Go ride. Travel Spa
Page 305 and 306:
36 mm Forks item new every ride/rac
Page 307 and 308:
Solutions: Check damper suspension
Page 309 and 310:
Control Direction Use the diagrams
Page 311 and 312:
Dropout Thickness Inspection Over t
Page 313 and 314:
Torque Values air-sprung 32mm FORKS
Page 315 and 316:
40 part description torque value in
Page 317 and 318:
Using the FOX High Pressure Pump Fo
Page 319 and 320:
Warranty Information Warranty Polic
Page 321 and 322:
• Also, thank you for taking spec
show all

2009 Fox Racing Shox Owner's Manual - Bike-Components

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?