2009 Fox Racing Shox Owner's Manual - Bike-Components

More documents

Recommendations

Info

2009+ 32 mm TALAS III (RL, RLC dampers) FOX 7 wt. Damper 160.0 Spring-side Oil Bath 10.0 FOX Float Fluid Main Chamber 3.0 Neg Chamber 3.0 2002-2006 Vanilla 100 & 130 (R, RL, RLC dampers) FOX 7 wt. Damper 160.0 Spring-side Oil Bath 30.0 2007-2008 Vanilla 140 (R damper) FOX 10 wt. Damper 160.0 FOX 7 wt. Spring-side Oil Bath 30.0 2007-2008 Vanilla 140 (RL, RLC dampers) FOX 7 wt. Damper 160.0 Spring-side Oil Bath 30.0 2005-2006 36 TALAS (R and RC2 dampers) FOX 10 wt. Damper 100.0 FOX 7 wt. Damper-side Oil Bath Spring-side Oil Bath 25.0 15.0 FOX Float Fluid IFP Chamber 3.0 Main Chamber 3.0 Neg Chamber 3.0 2007-2008 36 TALAS (R and RC2 dampers) FOX 10 wt. Damper 100.0 FOX 7 wt. Damper-side Oil Bath Spring-side Oil Bath 25.0 15.0 FOX Float Fluid IFP Chamber 3.0 Main Chamber 3.0 Neg Chamber 3.0 Fox Racing Shox 2009 Owners Manual Oil Volumes - Forks Page 195
2009+ 36 TALAS III (R and RC2 dampers) FOX 10 wt. Damper 100.0 FOX 7 wt. Damper-side Oil Bath Spring-side Oil Bath 25.0 15.0 FOX Float Fluid Main Chamber 3.0 Neg Chamber 3.0 2007-2008 36 FLOAT 160 (R and RC2 dampers) FOX 10 wt. Damper 100.0 FOX 7 wt. Damper-side Oil Bath 25.0 Spring-side Oil Bath 25.0 FOX Float Fluid Air Chamber 5.0 2006-2008 36 VAN (R and RC2 dampers) FOX 10 wt. Damper 100.0 FOX 7 wt. Damper-side Oil Bath Spring-side Oil Bath 25.0 25.0 2005-2008 40 (R and RC2 dampers) FOX 10 wt. Damper 122.0 FOX 7 wt. Damper-side Oil Bath Spring-side Oil Bath 50.0 50.0 Fox Racing Shox 2009 Owners Manual Oil Volumes - Forks Page 196
Page 1 and 2:
2009 Fox Racing Shox Owner’s Manu
Page 3 and 4:
Adjusting Rebound .................
Page 5 and 6:
Installing Your Fork ..............
Page 7 and 8:
Changing Springs ..................
Page 9 and 10:
32 TALAS RL (OE Edition) ..........
Page 11 and 12:
Welcome to FOX Racing Shox & FOX- H
Page 13 and 14:
Forks • Verify that the brakes on
Page 15 and 16:
Rear Shocks • If the shock ever l
Page 17 and 18:
Installing a 32 mm Fork Note: This
Page 19 and 20:
Brakes Linear-pull Linear-pull brak
Page 21 and 22:
Caution: Torque calipers to brake m
Page 23 and 24:
Warning! Do not use a tire if any m
Page 25 and 26:
1. Position your front wheel into t
Page 27 and 28:
Figure 4: 15QR Lever Resistance Poi
Page 29 and 30:
15QR Axle Lever Cam Tension Adjustm
Page 31 and 32:
8. To safely secure your front whee
Page 33 and 34:
32 FLOAT RLC weight travel 3.74 lbs
Page 35 and 36:
6. Being careful not to further com
Page 37 and 38:
6 (Factory setting) Average Rebound
Page 39 and 40:
5 (Factory setting) Average Compres
Page 41 and 42:
Travel Spacer Orientation Seal Orie
Page 43 and 44:
Installing Your Fork Be sure your f
Page 45 and 46:
Sag Troubleshooting Symptom Too muc
Page 47 and 48:
• Torque wrench • Oil drain pan
Page 49 and 50:
Seal Orientation Be sure that the l
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
1 803-00-078 32 mm Cartridge Seal K
Page 57 and 58:
F29 120 RLC, F29 100 RLC, F29 80 RL
Page 59 and 60:
5. Carefully sit on the bike and as
Page 61 and 62:
Knob Setting (CLICKS OUT FROM FULL
Page 63 and 64:
Knob Setting (CLICKS IN FROM FULL O
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Turn the knob clockwise to increase
Page 71 and 72:
32 F120 RL, F100RL, F80RL weight tr
Page 73 and 74:
Page 75 and 76:
6 Average Rebound (Factory setting)
Page 77 and 78:
Installing Your Fork (See “32 Rem
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
32 Remote RL Fork Setup Guide Figur
Page 85 and 86:
Figure 3: Positioning the Shimano L
Page 87 and 88:
Figure 6: Actuation Lever and Thumb
Page 89 and 90:
32 F120 R, F100R, F80R weight trave
Page 91 and 92:
Page 93 and 94:
6 Average Rebound (Factory setting)
Page 95 and 96:
Page 97 and 98:
Note: Sag and spring rate will self
Page 99 and 100:
Page 101 and 102:
32 TALAS RL weight travel features/
Page 103 and 104:
4. Install a zip tie with light fri
Page 105 and 106:
KNOB SETTING (CLICKS OUT FROM FULL
Page 107 and 108:
32 TALAS R weight travel features/a
Page 109 and 110:
4. Install a zip tie with light fri
Page 111 and 112:
KNOB SET- TING (CLICKS OUT FROM FUL
Page 113 and 114:
32 Vanilla RLC weight travel featur
Page 115 and 116:
Vanilla Coil Spring Setting Guideli
Page 117 and 118:
Locking Out the Fork The blue compr
Page 119 and 120:
9 Firm Compression Too firm and you
Page 121 and 122:
Page 123 and 124:
Adjusting Rebound The rebound knob
Page 125 and 126:
32 Vanilla R weight travel features
Page 127 and 128:
Vanilla Coil Spring Setting Guideli
Page 129 and 130:
3. Wipe the spring dry with a rag a
Page 131 and 132:
11. Using a crown race setter to in
Page 133 and 134:
The 36 is designed for use with dis
Page 135 and 136:
Fox Racing Shox 2009 Owners Manual
Page 137 and 138:
2. Thread the axle in until hand ti
Page 139 and 140:
4. Close both QR Levers by rotating
Page 141 and 142:
Page 143 and 144:
Page 145 and 146: Adjusting Low-Speed Compression (RC
Page 147 and 148: 4. Pull the air-shaft assembly from
Page 149 and 150: 36 TALAS RC2 & R weight travel feat
Page 151 and 152: 4. Using the 36 TALAS Air Spring Se
Page 153 and 154: 1 Slow Rebound Too slow and your fo
Page 155 and 156: Hydraulic Bottom-Out System The 36
Page 157 and 158: Installing Your Fork Be sure your f
Page 159 and 160: Harsh ride; full travel not utilize
Page 161 and 162: Adjusting Low-Speed Compression (RC
Page 163 and 164: Installing a 40 mm Fork 1. Verifyin
Page 165 and 166: Caution: Fox Racing Shox does not m
Page 167 and 168: Figure 4: 40 Upper Crown Installati
Page 169 and 170: 7. Installing the Front Wheel: Figu
Page 171 and 172: . Depending on the shape and size o
Page 173 and 174: 40 RC2 weight travel features/adjus
Page 175 and 176: 40 Coil Spring Settings FOX Part #
Page 177 and 178: Adjusting High-Speed Compression (R
Page 179 and 180: 2. Remove the black spring spacers
Page 181 and 182: ment in the fork or if it makes str
Page 183 and 184: 18. Slide the lower leg down furthe
Page 185 and 186: 3. Cut two four-inch (100 mm) strip
Page 187 and 188: 7. Pour a small amount of suspensio
Page 189 and 190: 11. Apply FLOAT Fluid to the foam r
Page 191 and 192: 15. If you cannot push the seal in
Page 193 and 194: Oil Volumes - Forks 2002-2009 Fork
Page 195: 2003-2006 TALAS 125 & 130 (R, RL, R
Page 199 and 200: General Maintenance There may be a
Page 201 and 202: Adjusting the ProPedal Switch The P
Page 203 and 204: DHX Air 4.0 weight 0.94 lbs. / 429
Page 205 and 206: 6. Repeat steps 2-5 until proper sa
Page 207 and 208: • For a softer ride, decrease the
Page 209 and 210: 5. Pressurize your main air chamber
Page 211 and 212: Boost Valve The Boost Valve creates
Page 213 and 214: General Maintenance Some things to
Page 215 and 216: Reading Your Spring Rate Adjusting
Page 217 and 218: Note: If the knob feels gritty duri
Page 221 and 222: Reading Your Spring Rate Adjusting
Page 223 and 224: For a softer ride, decrease the sho
Page 227 and 228: spring orientation. Correct spring
Page 229 and 230: VAN R weight 0.74 lbs. / 339 g (8.7
Page 231 and 232: Note: If after the preload ring eng
Page 233 and 234: ProPedal The ProPedal on your VAN R
Page 235 and 236: General Maintenance There may be a
Page 237 and 238: • OPEN • PROPEDAL Use each sett
Page 239 and 240: FLOAT RP2 weight features/ adjustme
Page 241 and 242: 6. Repeat steps 2-5 until proper sa
Page 243 and 244: FLOAT R (rear shock) weight 0.44 lb
Page 245 and 246: Air Spring Setting Guidelines Shock
Page 247 and 248:
Measuring Sag In general, sag on yo
Page 249 and 250:
"Stuck Down" Shock Procedure Under
Page 251 and 252:
emove wire rings and air sleeves. C
Page 253 and 254:
15. When replacing the air sleeve w
Page 255 and 256:
OE Custom Products These products a
Page 257 and 258:
General Maintenance There may be a
Page 259 and 260:
Adjusting Compression Some bicycles
Page 261 and 262:
32 TALAS RLC (OE Edition) weight tr
Page 263 and 264:
6. Being careful not to further com
Page 265 and 266:
6 (Factory setting) Average Rebound
Page 267 and 268:
5 (Factory setting) Average Compres
Page 269 and 270:
32 TALAS RL (OE Edition) weight tra
Page 271 and 272:
3. Using the Air Spring Settings ta
Page 273 and 274:
1 Slow Rebound Too slow and your fo
Page 275 and 276:
For safety reasons, it is recommend
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
32 F90 RL (OE Edition) weight trave
Page 285 and 286:
7. Compare your sag measurement to
Page 287 and 288:
12 Fast Rebound Too fast and you wi
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
F29 100 RL & F29 80 RL (OE Edition)
Page 299 and 300:
7. Compare your sag measurement to
Page 301 and 302:
12 Fast Rebound Too fast and you wi
Page 303 and 304:
14. Youre done. Go ride. Travel Spa
Page 305 and 306:
36 mm Forks item new every ride/rac
Page 307 and 308:
Solutions: Check damper suspension
Page 309 and 310:
Control Direction Use the diagrams
Page 311 and 312:
Dropout Thickness Inspection Over t
Page 313 and 314:
Torque Values air-sprung 32mm FORKS
Page 315 and 316:
40 part description torque value in
Page 317 and 318:
Using the FOX High Pressure Pump Fo
Page 319 and 320:
Warranty Information Warranty Polic
Page 321 and 322:
• Also, thank you for taking spec
show all

2009 Fox Racing Shox Owner's Manual - Bike-Components

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?