2009 Fox Racing Shox Owner's Manual - Bike-Components

General Maintenance
Some things to consider:
• If you ride in extreme conditions, service your shock more frequently. See “Service
Intervals” on page 303 to check the maintenance schedule for your shock.
• Wash your shock with soap and water only.
• Do not use a high pressure washer to clean your shock.
• Internal service should be performed by FOX Racing Shox or an Authorized Service
Center; see “Contact FOX” on page 321.
Before You Ride
1. Clean the outside of your shock with soap and water and wipe dry with a soft dry rag.
Caution: Do not use a high pressure washer on your shock.
2. Inspect entire exterior of shock for damage. The shock should not be used if any of the
exterior parts appear to be damaged. Contact your local dealer or FOX Racing Shox for
further inspection and repair.
3. Check that quick-release levers (or thru-axle pinch bolts) are properly adjusted and tightened.
4. Check headset adjustment. Adjust headset if loose, according to manufacturer’s recommendations.
5. Check that brake cables or hoses are properly fastened.
6. Check that the front and rear brakes operate properly on flat land.
Setting Sag
To set sag on your VAN R:
1. Measure sag (see “Measuring Sag” on page 246), and compare it to the recommended sag
setting shown in the Coil Spring Settings table below. Continue if the sag is not to specification.
2. Adjust the preload ring accordingly:
If sag is lower than specified in the table, turn the preload ring counterclockwise. Always
ensure that the spring is secure and does not freely move.
Note: After the preload ring engages the spring, turn the preload ring clockwise
one turn. If the preload ring needs to be turned counterclockwise from
this point to achieve proper sag, you will need to obtain a lower rate spring.
If sag is higher than specified in the table, turn the preload ring clockwise no more
than full two turns after the preload ring engages the spring.
Fox Racing Shox 2009 Owners Manual VAN R Page 229