2009 Fox Racing Shox Owner's Manual - Bike-Components

Installing Your Fork
(See “32 F-RL Remote” on page 75)
1. Remove the fork from all packaging. Be careful not to kink the control cable.
2. See “Installing a 32 mm Fork” on page 16 for the instruction procedures for installing a 32
mm fork. Proceed to install the fork steerer into the head tube of the bicycle.
Install and Orient the Shimano Actuation Lever
1. With a 3 mm hex key socket, loosen the handlebar clamp bolt on the underside of the Shimano
Lockout Lever Assembly (LLA).
Figure 2: Location of Handlebar Clamp Bolt
2. Remove the right-hand grip from the handlebar.
3. Slide the Shimano LLA onto the handlebar, in the direction shown in Figure 3: “Positioning
the Shimano LLA” on page 84. The LLA orientation should be so that the release lever is
facing towards the end of the handlebar, and the cable adjusting barrel is pointed towards
the front of the bike, above the hand brake lever assembly. Re-install the handlebar grip
into its original position.
Fox Racing Shox 2009 Owners Manual 32 Remote RL Fork Setup Guide Page 83