Instruction Manual - Beta Industries

More documents

Recommendations

Info

• To avoid incorrect handling, the UltraDottie II should only be used by trained personnel.. • UltraDottie II should only be used on dry and stable measuring surfaces. • UltraDottie II should be protected against chemicals, corrosive vapors, strong mechanical vibrations and impacts. • Use original Beta Industries spare parts and accessories only. • Use the original packaging exclusively when transporting the device. • The UltraDottie II case can be cleaned with a cloth moistened with soapy water 2of 9/49
2.3 Packaging and transport Always transport UltraDottie II in the original device case to avoid damage. Safeguard the measuring foot by pushing back the locking device. Beta Industries cannot be liable for damage to the UltraDottie II during transport that can be traced back to inadequate packaging or an unlocked measuring foot. 2.4 Basic equipment and accessories The UltraDottie II and the associated standard accessories are supplied in a fitted case. Please check the contents of the device case for completeness on delivery. The following components must be present: • UltraDottie II • User guide 2Contents 10/49
Page 1 and 2: UltraDottie II CTP Calibrator Opera
Page 3 and 4: 1 TABLE OF CONTENTS 3 2 GENERAL 5 2
Page 5 and 6: 3.8 UltraDottie IIII MAINTENANCE AN
Page 7 and 8: 2 General 2.1 Introduction Dear Bet
Page 9: 2.2 Safety 2.2.1 Warning For safety
Page 13 and 14: 2.5.2 Beta Target (Optional) The Be
Page 15 and 16: 3.8 UltraDottie IIII MAINTENANCE AN
Page 17 and 18: 3.2 First steps for use Release the
Page 19 and 20: uttons (see section 3.1). The funct
Page 21 and 22: Screen ruling in (lines/inch) Regul
Page 23 and 24: Screen angle in ° Logarithmic Refl
Page 25 and 26: • Unit displayed (cm or inch) •
Page 27 and 28: on the X axis of the diagram. After
Page 29 and 30: symbol, the measurement must be rep
Page 31 and 32: 33.5.2 Calibration As the UltraDott
Page 33 and 34: transmission mode. This is why no c
Page 35 and 36: 3.5.7.3 Dot diameter The diameter o
Page 37 and 38: 3.6 Visually checking the dot After
Page 39 and 40: 3.7 Measuring a plate characteristi
Page 41 and 42: Example: Measuring a plate characte
Page 43 and 44: 3.8 UltraDottie II maintenance and
Page 45 and 46: 4 APPENDIX 35 4.1 TECHNICAL DATA 37
Page 47 and 48: Measurement technique Sensor CMOS 6
Page 49 and 50: 4.2 Serial interface The UltraDotti

Instruction Manual - Beta Industries

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?