Instruction Manual - Beta Industries

More documents

Recommendations

Info

• Red LED (a standard plate is typically measured with the red LED) 3.2.1 Power-saving mode The UltraDottie II changes over automatically to power-saving mode after approximately 30 seconds. This is announced by displaying the ‘Sleep’ symbol. The display will then fade out. Tapping any button on the device will reproduce the last display. 3.2.2 Toolbar The toolbar appears on the left on the display and displays the functions available using symbols. A cursor (black frame surrounding the symbol) can be moved through the toolbar using the and buttons (see section 3.1). Functions available using symbols. A cursor (black frame surrounding the symbol) can be moved through the toolbar using the and 17/49
uttons (see section 3.1). The function designated by the cursor is executed by pressing the button. In normal operating mode the cursor moves after approximately 5 seconds to the default position. To re-position the cursor simply tap the or button. 3.2.3 Meaning of the symbols 3.2.3.1 Change display mode Next display Previous display Change to image display for a visual dot inspection Increase representation resolution to 12,700 ppi Reduce representation resolution to 6,350 ppi 18/49
Page 1 and 2: UltraDottie II CTP Calibrator Opera
Page 3 and 4: 1 TABLE OF CONTENTS 3 2 GENERAL 5 2
Page 5 and 6: 3.8 UltraDottie IIII MAINTENANCE AN
Page 7 and 8: 2 General 2.1 Introduction Dear Bet
Page 9 and 10: 2.2 Safety 2.2.1 Warning For safety
Page 11 and 12: 2.3 Packaging and transport Always
Page 13 and 14: 2.5.2 Beta Target (Optional) The Be
Page 15 and 16: 3.8 UltraDottie IIII MAINTENANCE AN
Page 17: 3.2 First steps for use Release the
Page 21 and 22: Screen ruling in (lines/inch) Regul
Page 23 and 24: Screen angle in ° Logarithmic Refl
Page 25 and 26: • Unit displayed (cm or inch) •
Page 27 and 28: on the X axis of the diagram. After
Page 29 and 30: symbol, the measurement must be rep
Page 31 and 32: 33.5.2 Calibration As the UltraDott
Page 33 and 34: transmission mode. This is why no c
Page 35 and 36: 3.5.7.3 Dot diameter The diameter o
Page 37 and 38: 3.6 Visually checking the dot After
Page 39 and 40: 3.7 Measuring a plate characteristi
Page 41 and 42: Example: Measuring a plate characte
Page 43 and 44: 3.8 UltraDottie II maintenance and
Page 45 and 46: 4 APPENDIX 35 4.1 TECHNICAL DATA 37
Page 47 and 48: Measurement technique Sensor CMOS 6
Page 49 and 50: 4.2 Serial interface The UltraDotti

Instruction Manual - Beta Industries

Create successful ePaper yourself

Delete template?

Save as template?