Instruction Manual - Beta Industries

More documents

Recommendations

Info

3.2.3.4 Other functions Transfer current record (binary image or characteristic curve) to the host PC Device is calculating (during measurement and data transfer) Device is changing over to power-saving mode Add reference value Delete reference value Restart and delete all previous settings 3.2.3.5 Symbols for measurement results Screen ruling in lines/cm or lines/inch Dot diameter in mm (based on a circular dot of the same surface area) 21/49
Screen angle in ° Logarithmic Reflectance Value 3.2.3.6 Status information Standard plate Polyester plate Paper Film Batteries need to be exchanged + Positive dot % - Negative dot % AM Regular screening FM Stochastic screening R Red illumination for plate measurement G Green illumination for plate measurement 22/49
Page 1 and 2: UltraDottie II CTP Calibrator Opera
Page 3 and 4: 1 TABLE OF CONTENTS 3 2 GENERAL 5 2
Page 5 and 6: 3.8 UltraDottie IIII MAINTENANCE AN
Page 7 and 8: 2 General 2.1 Introduction Dear Bet
Page 9 and 10: 2.2 Safety 2.2.1 Warning For safety
Page 11 and 12: 2.3 Packaging and transport Always
Page 13 and 14: 2.5.2 Beta Target (Optional) The Be
Page 15 and 16: 3.8 UltraDottie IIII MAINTENANCE AN
Page 17 and 18: 3.2 First steps for use Release the
Page 19 and 20: uttons (see section 3.1). The funct
Page 21: Screen ruling in (lines/inch) Regul
Page 25 and 26: • Unit displayed (cm or inch) •
Page 27 and 28: on the X axis of the diagram. After
Page 29 and 30: symbol, the measurement must be rep
Page 31 and 32: 33.5.2 Calibration As the UltraDott
Page 33 and 34: transmission mode. This is why no c
Page 35 and 36: 3.5.7.3 Dot diameter The diameter o
Page 37 and 38: 3.6 Visually checking the dot After
Page 39 and 40: 3.7 Measuring a plate characteristi
Page 41 and 42: Example: Measuring a plate characte
Page 43 and 44: 3.8 UltraDottie II maintenance and
Page 45 and 46: 4 APPENDIX 35 4.1 TECHNICAL DATA 37
Page 47 and 48: Measurement technique Sensor CMOS 6
Page 49 and 50: 4.2 Serial interface The UltraDotti

Instruction Manual - Beta Industries

Create successful ePaper yourself

Delete template?

Save as template?